Toshiba B-492L, R-TH10 owner manual ∙ Descriptions of the Maintenance Counter

APPENDIX 4 SYSTEM MODE EO1-33032

A4.8 Additional Information

A4.8.2 Maintenance Counter and Parameter Check Print Sample and Descriptions (Cont.)

∙Descriptions of the Maintenance Counter

No.	Item	Count Condition	Range
(1)	Total media distance covered	Counted when the feed motor is driven to feed,	0.0 to 2000.0 km
		print and issue the media. (Also counted
(2)	Media distance covered		0.0 to 181.9 km
		during back feed.) See NOTE 6.
(3)	Print distance	Counted while printing. (Back feeding is not	0.0 to 200.0 km
		counted.) See NOTE 2.
		Counts every print head up and down
(4)	Head up/down count	movement using the ribbon saving solenoid.	0 to 2000000 times
		(Up + down=1 count) See NOTE 3.
		Counts when the ribbon motor is driven to feed,
(5)	Ribbon motor operating time	print and issue media. (The driving time is also	0 to 2000 hours
		counted during back feed.) See NOTE 4.
(6)	Head up solenoid operating	Counted during the ribbon saving.	0 to 1000 times
	time	See NOTE 4.
(7)	RS-232C hardware error count	Counted when a parity, overrun or framing	0 to 255 times
		error occurs. See NOTE 5.
(8)	System error count	Counted when any error occurs.	0 to 15 times
(9)	Momentary power failure count	Counts the number of times the power restores	0 to 15 times
		while the CPU is busy after reset.

NOTES:

1.The item from (2) through (9) are initialized to “0” after RAM clear.

2.If the Print distance is 5.5m or less, it is rounded down and no data is added to the memory at power off.

3.If the count is 31 counts or less, it is rounded down and no data is added to the memory at power off.

4.If the driving time is 27 sec. or less, it is rounded down and no data is added to the memory at power off.

5.When more than 1 byte-data is continuously sent, they are counted by byte.

6.If the media distance covered is 69.4 cm or less, it is rounded down and no data is added to the memory at power off.

∙Descriptions of the Parameters

No.	Item	Contents
(10)	Feed length fine adjustment (PC), (KEY)	-50.0 mm to +50.0 mm
(11)	Strip position fine adjustment (PC), (KEY)	-50.0 mm to +50.0 mm
(12)	Back feed length fine adjustment (PC), (KEY)	-9.9 mm to +9.9 mm
(13)	Print tone fine adjustment (Thermal transfer), (PC),	-10 step to +10 step
	(KEY)
(14)	Print tone fine adjustment (Thermal direct), (PC),	-10 step to +10 step
	(KEY)
(15)	Ribbon rewind motor driving voltage fine adjustment	-15 step to +0 step
	(PC), (KEY)
(16)	Ribbon feed motor driving voltage fine adjustment	-15 step to +0 step
	(PC), (KEY)
(17)	Strip Motor driving speed fine adjustment (PC), (KEY)	+0 to +4
(18)	X axis fine adjustment	-99.5 mm to +99.5 mm

A4-25