Toshiba B-492L, R-TH10 owner manual Issue Mode Selection, Label Length Setting

Strip mode

Batch mode

EO1-33032 A4.6 Test Print

APPENDIX 4 SYSTEM MODE

A4.6 Test Print (Cont.)	Issue Mode Selection
	Select the issue mode for the test print by selecting between “[S]
	NORMAL”7<3(>6@1250Batch mode)$/	and “[H] PEEL OFF” (Strip mode).

NOTE:

Press and hold the [RESTART] or [FEED] key to advance the values quickly and continuously. To stop, release the key.

[RESTART] 7<3(>61250+@3((/$2))/

[FEED]

After selecting/$%(//(1the￿Issue￿￿PPMode, press the [PAUSE] key to go to Label Length Setting.

Label Length Setting

Select the label length for the test print in a range from 5 mm to 999 mm.

[RESTART]

[FEED] /$%(//(1￿￿￿￿PP

NOTE:

When “PAPER FEED” is selected, the printer feeds the media to the correct print start position for the selected conditions.

When “PAPER NO FEED” is selected, the printer makes no pre-feed to set the print start position. If the print start position adjustment is unnecessary, Select "PAPER NO FEED" and save media.

[FEED] key:	Pressing the [FEED] key once causes a –1 mm
	change, down to 5 mm.

[RESTART]key: Pressing the [RESTART] key once causes a +1 mm

Paper Feed3$3(5)(('Selection

change, up to 999 mm.

After selecting the label length, press the [PAUSE] key to go to Paper Feed Selection.

Select whether or not a paper feed is performed.

[RESTART]	3$3(512)((')(('	Paper feed is
		available.
[FEED]		Paper feed is not
		available.

After selecting the paper feed, press the [PAUSE] key. If "PAPER FEED" was selected the printer will feed the media. The display returns to the “<4>TEST PRINT”.

A4-17