Muratec F-98 operating instructions Programming a F-Code polling, P4Fax Number 5552208

7 Use the numeric keypad to enter the ITU-Tsub-address for the box to which you want to send the document. Here, we’ve entered 123456:

Enter Sub-Address 123456_

8 Press ENTER. The LCD shows:

Enter Password

_

Note: If the password for the box is not entered, press ENTER and then skip to step 10.

9 Use the numeric keypad to enter the appropriate ITU-Tpassword for the box. Here, we’ve entered 654321:

Enter Password 654321_

When finished, press ENTER.

10 If you want the transmission to begin immediately every time you press the key, press ENTER and skip to step 13.

If you want to delay the transmission (to take advantage of lower phone rates, for example), press COM-OPTIONS,ENTER.

11 There’s a choice to make. Instruct your fax to carry out this delayed command in one of the following ways:

Option 1: Perform the command once at a certain time on a certain day of the month. (For example, “Do this at 5:05 PM on the 30th.”)

To select this option, use the numeric keypad to enter the date and time when the fax should perform the command:

Delayed

Enter Time: 30/17:05

Option 2: Perform the command at a certain time each day you press the key. (For example, “Do this at 5:05 PM today.”)

To select this option, use the numeric keypad to enter 0, 0 (i. e., 00), and then the time when the fax could perform the command:

Delayed

Enter Time: 00/17:05

12 Press ENTER, ENTER.

Beyond the basics

13 The LCD now displays the next programmable one-touch key.

If you do not want to enter or change any other key’s programming, press STOP to return your machine to its usual standby mode.

If you do want to enter or change this key’s programming, go back to step 3. If you want to enter or change another key’s programming, go back to step 2.

Programming a F-Code polling

Note: To erase a programmable one-touch key, refer to page 2.41.

Note: For this operation to work, three things must be true:

•The document which you’re polling must exist on the remote fax’s F-Code (ITU-T-standard sub-addressing/password) box.

•You must know the remote fax’s ITU-Tsub-address and password (if any) for each box you wish to poll.

To program an F-Code polling into a programmable one-touch key:

1 Press PROGRAM, C, 1, ENTER. The LCD either shows:

Select Program No.

P1:No Number Stored

… or indicates a command is already programmed into this key.

If P1 is the key you want to program, skip to step 3. (However, our examples from here will say “P4” rather than “P1.”)

2 Select the key in which you want to program a command or change a previ- ously stored command and then press it. Here, we’ve selected P4.

Select Program No.

P4:No Number Stored

3 If you change your mind and want to select a different programmable one- touch key, go back to step 2 before going on to step 4.

4 Press ENTER. The LCD now shows either

P4:Fax Number	or	P4:Fax Number
_		9-5552208_

2.39