Sony NSX-AJ80 manual Setting the Clock, Dimmer Mode, Flash Window, Press Clock, Press Enter or a

Page 7

1Press ECO.

“ECO MODE” will be displayed.

2Press ENTER within 4 seconds.

The current power-economizing mode status will be displayed.

3Turn MULTI JOG within 4 seconds to select one of the power-economizing modes.

Example : When “ECO ON” is selected.

4Press ENTER within 4 seconds.

If the clock is not set, the unit does not black out.

Instead, the DEMO will begin when the power is turned off.

DIMMER MODE

To change the display dimmer mode

1Press ECO repeatedly until “DIM MODE” is displayed.

2Within 4 seconds, press ENTER.

3Within 4 seconds, turn MULTI JOG to select one of the dimmer modes changed cyclically as below.

4Within 4 seconds, press ENTER.

DIM-OFF DIMMER 1 DIMMER 2 DIMMER 3

“DIM-OFF” mode is the brightest and “DIMMER 3” mode is the dimmest. In “DIMMER 3” mode, the spectrum analyzer and the button illumination light off in addition.

FLASH WINDOW

The light above the cassette holders light up while the unit is being powered on.

To turn off the light above the cassette holders, press s while pressing TAPE. To turn the light back on, repeat the operation.

SETTING THE CLOCK

PREPARATIONS

 

1Press CLOCK.

When using the remote control, press CLOCK while pressing

SHIFT.

The clock is displayed. (The “:” between the hours and minutes flashes.)

2 Within 4 seconds, turn MULTI JOG to designate En the hour and the minute.

Turning MULTI JOG changes both the hour and the minute. for gis also available in place of MULTI JOG. Holding these buttons down will vary the time rapidly.

3Press ENTER or a.

The clock starts from 00 seconds.

To restore an original clock setting

Press CLOCK before completing step 3 to restore the previous time setting. This cancels any new setting.

To view the clock when another display is in the display

Press CLOCK. The time is displayed for 4 seconds and then the original display reappears. However, the clock cannot be displayed during recording.

To switch to the 24-hour standard

Press CLOCK and then press s within 4 seconds.

Repeat the same procedure to restore the 12-hour standard.

In the 12-hour standard, “AM 12:00” indicates midnight and “PM 12:00” indicates noon.

If the clock display flashes

If the display flashes when the clock is displayed, it indicates that the clock has stopped due to a power failure or the removal of the power cord. The current time needs to be reset.

If the power-economizing mode (page 6) is on, the unit blacks out when the power is turned off. To view the clock, press CLOCK so that the time is displayed for 4 seconds.

ENGLISH 7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents NSX-AJ80 Installation PrecautionsElectric Power Table of Contents Positioning the Speakers Before connecting the AC cordConnections 1Connect the right speaker to the main unit4Connect the supplied antennas Connecting AN Outdoor Antenna2Connect the left speaker to the main unit 3Connect the satellite speakers to the main unitSetting Power Economizing Mode Remote ControlBefore Operation Press Clock Setting the ClockDimmer Mode Flash WindowBBE System Audio Adjustments Graphic EqualizerVolume Selecting the Programmed Equalization CurveWithin 8 seconds, press Enter Setting a NEW Equalization Curve ManuallyStoring the NEW Equalization Curves Press GEQ, followed by Enter within 4 secondsDSP Surround Selecting a Programmed DSP Surround ModePress Satellite to activate the 3-Amp Panorama Sound System Channel Multi-Amplifier System Presetting Stations Manual TuningPreset Number Tuning Press d to start play Basic OperationsMusic Sensor Continuous PlayAbout cassette tapes Playing Discs Loading DiscsPlayback Random /REPEAT Play Programmed PlayBlank Skip Play Inserting Blank Spaces Basic RecordingRecording CD Playing To stop dubbing Dubbing a Tape ManuallyPress TAPE/DECK 1/2 to select deck Press Sync DUB once or twice to start recordingPress w REC/REC Mute to start recording on AI Edit RecordingInsert the tape into deck Press CD and load the discs Press CD EDIT/CHECK onceTo change the program of each side Press CD and load the discs Press CD EDIT/CHECK twiceRepeat for the rest of the tracks for side Press wREC/REC Mute to start recordingVocal FADER/MULTIPLEX Functions Microphone MixingKaraoke Recording Repeat to reserve other tracks Press d to start play Karaoke ProgramTo cancel the sleep timer Setting the Sleep TimerTimer Karaoke To check the time remaining until the power is turned offPrepare the source Timer RecordingAdjust the volume Press Power to turn off the powerPress s once Other Features TimerPress s twice to stop the remaining two numbers CD Digital OUT Optical Jack VIDEO/AUX JacksMD Jacks Line OUT JacksTroubleshooting Guide Care and MaintenanceGeneral Other Connections Copyright SpecificationsParts Index Energía eléctrica PrecaucionesAdvertencia InstalaciónIndice Importante Conexiones1Conecte el altavoz derecho a la unidad principal Antes de conectar el cable de CA4Conecte las antenas suministradas Conexion DE UNA Antena Exterior2Conecte el altavoz izquierdo a la unidad principal 3Conecte los altavoces auxiliares a la unidad principalAntes DE LA Operacion Control RemotoActivacion DEL Modo DE Ahorro DE Energía Ventanilla Parpadeante Modo DE Intensidad DE IluminacionAjustes DE Audio Ecualizador Grafico Pulse GEQ, seguido de Enter antes de que Pasen 4 segundos Ajuste Manual DE UNA Curva DE Ecualizacion NuevaAlmacenamiento DE Curvas DE Ecualizacion NuevasCuando la fuente musical sea mono Tres AmplificadoresSeleccion DE UN Modo DSP Surround Programado Para visualizar el modo DSP Surround actualPiano Sistema multiamplificador de 4 canalesPulse fDOWN o gUP para seleccionar una Emisora Sintonizacion ManualPreajuste DE Emisoras Sintonizacion Mediante Numero DE PreajusteRadiolade Operaciones BasicasPulseTAPE/DECK 1/2 y Push Eject zpara abrir el portacasete Pulse d para iniciar la reproducciónSensor Musical Reproduccion ContinuaAcerca de las cintas de casete Compactosdiscos Dereproduccion Introduccion DE DiscosReproduccion DE Discos Cintasde ReproduccionPulse Disc Direct Play 1-3 para seleccionar un Disco Reproduccion ALEATORIA/ Repeticion DE ReproduccionReproduccion CON Salto DE Secciones EN Blanco Pulse CD Blank SkipInsercion DE Espacios SIN Grabar Grabacion BasicaDiscos Pulse una o dos veces Sync DUB para iniciar la grabación Pulse TAPE/DECK 1/2 para seleccionar la platinaPara detener el copiado De la primera cara Grabacion CON Edicion AIInserte la cinta en la platina Pulse wREC/REC Mute para iniciar la grabaciónPara cambiar el programa de cada cara Grabacion CON Edicion ProgramadaFunciones DE Desvanecimiento DE VOZ/MULTIPLEX Mezcla MicrofonicaKaraoke Grabacion Programa DE Karaoke Por el temporizador Para cancelar el temporizador para dormirPrepare la fuente Ajuste el volumenPulse Power para desconectar la alimentación Grabacion CON TemporizadorPulse dos veces spara detener los dos números Restantes Otras CaracteristicasOtras Caracteristicas Temporizador Pulse una vez sToma CD Digital OUT Optical Tomas VIDEO/AUXTomas MD Tomas Line OUTSeccion DE LA Platina Generalidades Otras ConexionesGeneralidades Seccion DEL SintonizadorCopyright Derechos DE Autor EspecificacionesCordon d’alimentation secteur Signification des symboles graphiquesAvertissement Energie électriqueTable DES Matieres Positionnement des enceintes Connexions1Connecter l’enceinte droite à l’appareil principal Avant de brancher le cordon secteur4Connecter les antennes fournies Connexion D’UNE Antenne Exterieure2Connecter l’enceinte gauche à l’appareil principal 3Connecter les enceintes satellites à l’appareil principalAvant L’UTILISATION TelecommandeReglage DE L’HORLOGE Mode VariateurFenetre Clignotante Systeme Super T-BASS Reglages AudioEgaliseur Graphique Systeme BBEDans les huit secondes, appuyer sur Enter Reglage Manuel D’UNE Nouvelle Courbe D’EGALISATIONMemorisation DES Nouvelles Courbes D’EGALISATION HighTrois Amplificateurs Selection D’UN Mode Surround DSP ProgrammePour afficher le mode Surround DSP courant Surround DSPSystème multi-amplificateur à quatre canaux Appuyer sur f Down ou g UP pour sélectionner une station Accord ManuelMemorisation DE Stations Accord PAR Numero DE PrereglageAppuyer sur d pour démarrer la lecture Operations DE BaseCassettesde Senseur DE Musique Lecture ContinueAu sujet des cassettes Lecture DE Disques Mise EN Place DE DisquesCassettes Appuyer sur CD Blank Skip Lecture ProgrammeeLecture ALEATOIRE/REPETEE Lecture Avec Saut DES BlancsInsertion D’ESPACES Blancs Enregistrement DE BaseCompacts Pour arrêter la duplication Appuyer sur TAPE/DECK 1/2 pour sélectionner La platine’enregistrement sur la première face Appuyer sur w REC/REC Mute pour démarrerInsérer la cassette dans la platine Face Répéter l’étape 5 pour le reste des plages de la Face aPour changer le programme de chaque face Fonctions Vocal FADER/MULTIPLEX Mixage Avec MicrophoneKaraoke Enregistrement Shift Programme DE KaraokeRépéter l’étape 3 pour réserver d’autres plages Pour annuler la minuterie d’arrêt Minuterie KaraokePréparer la source Enregistrement Commande PAR MinuterieRégler le volume Appuyer sur Power pour mettre l’appareil hors TensionPour réinitialiser le jeu Demo Appuyer une fois sur sCaracteristiques Pour annuler le jeu DemoPrise CD Digital OUT Optical Prises VIDEO/AUXPrises MD Prises Line OUTSoins ET Entretien EN CAS DE ProblemeGeneralites Autres Connexions Droits D’AUTEUR
Top Page Image Contents