Sony NSX-AJ80 manual Timer Recording, Adjust the volume, Prepare the source

Page 24
REC appears on the

5Adjust the volume.

The source sound will play at the volume level set in this step when the power is turned on by the timer.

If the volume level is set to 21 or higher, however, it will automatically be set to 20 when the power is turned on.

6Prepare the source.

To listen to a CD, load the disc to be played first on tray 1. To listen to a tape, insert the tape into deck 1 or 2.

To listen to the radio, select the band and tune in to a station.

7Press POWER to turn off the power.

When the timer-on time is reached, the unit turns on and begins play with the selected source.

You can change the source that was selected in step 1 by pressing one of the function buttons before pressing ENTER or ain step 3.

To check the timer setting

Press TIMER.

The timer-on time, the selected source, and the duration for the timer-activated period will be displayed for 4 seconds.

To change any of the previous setting

Carry out from step 1.

However, if you do not change the timer-on time, in step 3 just press ENTER twice and continue from step 4.

To cancel the timer standby mode temporarily

Press TIMER repeatedly so that disappears.

To restore the timer standby mode, press again to display .

Using the unit while the timer is set

You can use the unit normally after setting the timer. Before turning off the power, carry out steps 5 and 6.

•Timer playback and timer recording will not begin unless the power is turned off.

•Connected equipment cannot be turned on and off by the built- in timer of this unit. Use an external timer.

TIMER RECORDING

Timer recording is applicable for TUNER and VIDEO/AUX (with an external timer) sources only.

Press either TUNER/BAND or VIDEO/AUX to select a source, then press TIMER repeatedly until

display. Within 6 seconds, carry out the steps of “SETTING THE TIMER” from step 3 and insert the tape to be recorded on into deck 2 after step 6.

•If the timer recording is done with the economizing mode (page 6) set to “ECO ON” or “ECO AUTO” and the power turns off, the dimmer mode will be set to dimmest and the volume level will be 0 (minimum level) the next time the power is turned on.

•You cannot use the timer function to record from a CD or tape.

•You can check the timer setting by pressing TIMER even while the power is off. In this case, if you press ENTER or awithin 4 seconds after pressing TIMER, you can enter the timer setting mode and change the previous setting.

24 ENGLISH

Page 23 Page 25
Image 24
Page 23 Page 25
Contents NSX-AJ80 Precautions InstallationElectric Power Table of Contents Before connecting the AC cord Connections1Connect the right speaker to the main unit Positioning the SpeakersConnecting AN Outdoor Antenna 2Connect the left speaker to the main unit3Connect the satellite speakers to the main unit 4Connect the supplied antennasRemote Control Setting Power Economizing ModeBefore Operation Setting the Clock Dimmer ModeFlash Window Press ClockAudio Adjustments Graphic Equalizer VolumeSelecting the Programmed Equalization Curve BBE SystemSetting a NEW Equalization Curve Manually Storing the NEW Equalization CurvesPress GEQ, followed by Enter within 4 seconds Within 8 seconds, press EnterSelecting a Programmed DSP Surround Mode DSP SurroundPress Satellite to activate the 3-Amp Panorama Sound System Channel Multi-Amplifier System Manual Tuning Presetting StationsPreset Number Tuning Basic Operations Press d to start playContinuous Play Music SensorAbout cassette tapes Loading Discs Playing DiscsPlayback Programmed Play Random /REPEAT PlayBlank Skip Play Basic Recording Inserting Blank SpacesRecording CD Playing Dubbing a Tape Manually Press TAPE/DECK 1/2 to select deckPress Sync DUB once or twice to start recording To stop dubbingAI Edit Recording Insert the tape into deckPress CD and load the discs Press CD EDIT/CHECK once Press w REC/REC Mute to start recording onPress CD and load the discs Press CD EDIT/CHECK twice Repeat for the rest of the tracks for sidePress wREC/REC Mute to start recording To change the program of each sideMicrophone Mixing Vocal FADER/MULTIPLEX FunctionsKaraoke Recording Karaoke Program Repeat to reserve other tracks Press d to start playSetting the Sleep Timer Timer KaraokeTo check the time remaining until the power is turned off To cancel the sleep timerTimer Recording Adjust the volumePress Power to turn off the power Prepare the sourceOther Features Timer Press s oncePress s twice to stop the remaining two numbers VIDEO/AUX Jacks MD JacksLine OUT Jacks CD Digital OUT Optical JackCare and Maintenance Troubleshooting GuideGeneral Other Connections Specifications CopyrightParts Index Precauciones AdvertenciaInstalación Energía eléctricaIndice Conexiones 1Conecte el altavoz derecho a la unidad principalAntes de conectar el cable de CA ImportanteConexion DE UNA Antena Exterior 2Conecte el altavoz izquierdo a la unidad principal3Conecte los altavoces auxiliares a la unidad principal 4Conecte las antenas suministradasControl Remoto Antes DE LA OperacionActivacion DEL Modo DE Ahorro DE Energía Modo DE Intensidad DE Iluminacion Ventanilla ParpadeanteAjustes DE Audio Ecualizador Grafico Ajuste Manual DE UNA Curva DE Ecualizacion Nueva Almacenamiento DE Curvas DEEcualizacion Nuevas Pulse GEQ, seguido de Enter antes de que Pasen 4 segundosTres Amplificadores Seleccion DE UN Modo DSP Surround ProgramadoPara visualizar el modo DSP Surround actual Cuando la fuente musical sea monoSistema multiamplificador de 4 canales PianoSintonizacion Manual Preajuste DE EmisorasSintonizacion Mediante Numero DE Preajuste Pulse fDOWN o gUP para seleccionar una EmisoraOperaciones Basicas PulseTAPE/DECK 1/2 y Push Eject zpara abrir el portacasetePulse d para iniciar la reproducción RadioladeReproduccion Continua Sensor MusicalAcerca de las cintas de casete Introduccion DE Discos Reproduccion DE DiscosCintasde Reproduccion Compactosdiscos DereproduccionReproduccion ALEATORIA/ Repeticion DE Reproduccion Reproduccion CON Salto DE Secciones EN BlancoPulse CD Blank Skip Pulse Disc Direct Play 1-3 para seleccionar un DiscoGrabacion Basica Insercion DE Espacios SIN GrabarDiscos Pulse TAPE/DECK 1/2 para seleccionar la platina Pulse una o dos veces Sync DUB para iniciar la grabaciónPara detener el copiado Grabacion CON Edicion AI Inserte la cinta en la platinaPulse wREC/REC Mute para iniciar la grabación De la primera caraGrabacion CON Edicion Programada Para cambiar el programa de cada caraMezcla Microfonica Funciones DE Desvanecimiento DE VOZ/MULTIPLEXKaraoke Grabacion Programa DE Karaoke Para cancelar el temporizador para dormir Por el temporizadorAjuste el volumen Pulse Power para desconectar la alimentaciónGrabacion CON Temporizador Prepare la fuenteOtras Caracteristicas Otras Caracteristicas TemporizadorPulse una vez s Pulse dos veces spara detener los dos números RestantesTomas VIDEO/AUX Tomas MDTomas Line OUT Toma CD Digital OUT OpticalGeneralidades Otras Conexiones GeneralidadesSeccion DEL Sintonizador Seccion DE LA PlatinaEspecificaciones Copyright Derechos DE AutorSignification des symboles graphiques AvertissementEnergie électrique Cordon d’alimentation secteurTable DES Matieres Connexions 1Connecter l’enceinte droite à l’appareil principalAvant de brancher le cordon secteur Positionnement des enceintesConnexion D’UNE Antenne Exterieure 2Connecter l’enceinte gauche à l’appareil principal3Connecter les enceintes satellites à l’appareil principal 4Connecter les antennes fourniesTelecommande Avant L’UTILISATIONMode Variateur Reglage DE L’HORLOGEFenetre Clignotante Reglages Audio Egaliseur GraphiqueSysteme BBE Systeme Super T-BASSReglage Manuel D’UNE Nouvelle Courbe D’EGALISATION Memorisation DES Nouvelles Courbes D’EGALISATIONHigh Dans les huit secondes, appuyer sur EnterSelection D’UN Mode Surround DSP Programme Pour afficher le mode Surround DSP courantSurround DSP Trois AmplificateursSystème multi-amplificateur à quatre canaux Accord Manuel Memorisation DE StationsAccord PAR Numero DE Prereglage Appuyer sur f Down ou g UP pour sélectionner une stationOperations DE Base Appuyer sur d pour démarrer la lectureCassettesde Lecture Continue Senseur DE MusiqueAu sujet des cassettes Mise EN Place DE Disques Lecture DE DisquesCassettes Lecture Programmee Lecture ALEATOIRE/REPETEELecture Avec Saut DES Blancs Appuyer sur CD Blank SkipEnregistrement DE Base Insertion D’ESPACES BlancsCompacts Appuyer sur TAPE/DECK 1/2 pour sélectionner La platine Pour arrêter la duplicationAppuyer sur w REC/REC Mute pour démarrer ’enregistrement sur la première faceInsérer la cassette dans la platine Répéter l’étape 5 pour le reste des plages de la Face a FacePour changer le programme de chaque face Mixage Avec Microphone Fonctions Vocal FADER/MULTIPLEXKaraoke Enregistrement Programme DE Karaoke ShiftRépéter l’étape 3 pour réserver d’autres plages Minuterie Karaoke Pour annuler la minuterie d’arrêtEnregistrement Commande PAR Minuterie Régler le volumeAppuyer sur Power pour mettre l’appareil hors Tension Préparer la sourceAppuyer une fois sur s CaracteristiquesPour annuler le jeu Demo Pour réinitialiser le jeu DemoPrises VIDEO/AUX Prises MDPrises Line OUT Prise CD Digital OUT OpticalEN CAS DE Probleme Soins ET EntretienGeneralites Autres Connexions Droits D’AUTEUR
Top Page Image Contents