Fabric softener compartment (Letter D in Dispenser Illustration)
Add 1/4cup (60 mL) liquid fabric softener to this compartment. Fabric softener will be automatically dispensed in the final rinse or in the 2ND RINSE, if selected.
•Do not fill beyond the "MAX" level.
1.To pause the washer at any time, select STOR
2.To continue the cycle, select and hold START (for approximately 1 second).
Not all Options and Modifiers are available with all Cycles.
Cycles, Options and Modifiers can be changed anytime before START is selected.
To stop a cycle and select a new cycle
1.Select STOP once.
2.Select desired cycle.
3.Select the desired MODIFIERS &OPTIONS.
4.Select and hold START (for approximately I second) to restart the washer at the beginning of the new cycle.
To cancel a cycle
1.Select STOP twice.
2.The washer powers down, the door unlocks, and clothes can be removed.
NOTE: If the water level or the temperature is too high, the washer will drain automatically before the door unlocks.
To change Options or Modifiers after the cycle has started
1.Select STOP.
2.Select the desired MODIFIERS &OPTIONS. If the option or modifier are not available, the machine will beep.
3.Select and hold START (for approximately 1 second) to continue the cycle.
To drain the washer manually
1.Select STOP.
2.Select RINSE/DRAIN & SPIN.
3.Press the 2ND RINSE button to deselect the 2nd Rinse option.
4.Select and hold START (for approximately 1 second) to begin the drain.
5.When the spin is complete, the door unlocks. Items can be removed from the washer.
These lights show which portion of the cycle the washer is operating. They also indicate when you can add an additional item to the wash cycle and when the controls are locked.
Add a Garment Q
Prewash / Wash 9
Rinse
Spin
Clothes Clean _
Controls Locked i
Door Locked/_
Adding items
You can add items to the washer after the wash cycle has started, if the ADD A GARMENT status light is illuminating. All cycles have this feature except Rinse/Spin, Drain/Spin, and Clean Washer.
To add items
1.Select STOR The washer door unlocks, and items can be added.
2.To continue the cycle, close the door and select and hold START (for approximately 1 second).
NOTE: To add garments after the ADD A GARMENT period is |
|
over, the wash cycle needs to be canceled, the items added, and |
|
a new wash cycle started. | iiii |
| |
Clothes Clean |
|
The Clothes Clean light comes on when the cycle is complete. |
|
Light will stay on until door is opened. |
|
Locking controls
The Control Lock avoids unintended use of the washer. You can also use the control lock feature to avoid unintended cycle or option changes during a cycle. When CONTROLS LOCKED is lit, all buttons are disabled except for STOP and POWER. You can lock the controls while the washer is operating.
To lock the controls
Select and hold CYCLE SIGNAL for 3 seconds.
The CONTROLS LOCKED status light illuminates.
To unlock the controls
Select and hold CYCLE SIGNAL for 3 seconds until the
CONTROLS LOCKED Status light turns off.
Estimated Time Remaining
The cycle times vary automatically based on your water pressure, water temperature, detergent, and clothes load. The cycle time will be extended if oversudsing occurs or the load is unbalanced. The SUDs routine removes extra suds and assures proper rinsing of your garments. The options you select will also affect the cycle times that are shown in the Preset Cycle Settings table. The Estimated Time Remaining can change up to 30 minutes under extreme conditions.
Door Locked
When the status light illuminates, the door is locked.
15