:: l!) i:ii:i:i'i!i:: iii i
Properly leveling and locking the feet on your washer avoids excessive noise and vibration,
1.Check that the four Iocknuts on the washer feet are tightened against the washer cabinet using a 14 mm
2.Place the washer in its final location and check the levelness of the washer. The washer should not move front to back, side to side, or diagonally when pushed on its top edges. Make sure all four feet are stable and resting on the floor.
111iii !]ii: 1:: i, iii:!iiii,::1::
1.Check the electrical requirements. Be sure that you have the correct electrical supply and the recommended grounding method. See "Electrical Requirements."
2.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.
3.Check that you have all of your tools.
4.Dispose of/recycle all packaging materials.
5.Check that the water faucets are on,
6.Check for leaks around faucets and inlet hoses.
3.If the washer is not level, move the washer out slightly before tipping back, First prop the front with a wood block, loosen the Iocknuts and adjust the feet as necessary; then prop the back and adjust feet as necessary. Repeat steps
IMPORTANT" All four feet must be tightened. If the Iocknuts are not tight against the washer cabinet, the washer may vibrate.
ElectdcaB Shock Hazard
Plug into a grounded 3 prong outlet,
Do not remove ground prong,
Do not use an adapter,
Do not use an extension cord,
Falure to foiow these instructions can resumt in death, fire, or e[ectricam shock,
7.Plug into a grounded 3 prong outlet.
8.Read "Washer Use."
g.To test and to clean your washer, measure 1/2the detergent manufacturer's recommended amount of HE High Efficiency detergent for a
Use only HE High Efficiency detergent.
11