Indesit PWDE 7125 W First wash cycle, Technical data, Cable should not be bent or compressed

Connecting the drain hose

￿The cable should not be bent or compressed.

GB

65 - 100 cm

Connect the drain hose, without bending it, to a drain duct or a wall drain situated between 65 and 100 cm from the floor;

￿The power supply cable must only be replaced by authorised technicians.

Warning! The company shall not be held responsible in the event that these standards are not observed.

The first wash cycle

Once the appliance has been installed, and before you use it for the first time, run a wash cycle with

alternatively, place it over the edge of a basin, sink or tub, fastening the duct supplied to the tap (see figure). The free end of the hose should not be underwater.

detergent and no laundry, using wash cycle number 2.

￿We advise against the use of hose extensions; if it is absolutely necessary, the extension must have the same diameter as the original hose and must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the electricity socket, make sure that:

•the socket is earthed and complies with all applicable laws;

•the socket is able to withstand the maximum power load of the appliance as indicated in the Technical data table (see opposite);

•the power supply voltage falls within the values indicated in the Technical data table (see opposite);

•the socket is compatible with the plug of the washer-dryer. If this is not the case, replace the socket or the plug.

￿The washer-dryer must not be installed outdoors, even in covered areas. It is extremely dangerous to leave the appliance exposed to rain, storms and other weather conditions.

￿When the washer-dryer has been installed, the electricity socket must remain within easy reach.

￿Do not use extension cords or multiple sockets.

Technical data

Model	PWDE 7125 W
	width 59,5 cm
Dimensions	height 85 cm
	depth 55 cm
Capacity	from 1to 7 kg for wash programme
	from 1 to 5 kg for the drying programme
Electrical	please refer to the technical data
connections	plate fixed to the machine
	maximum pressure 1 MPa (10 bar)
Water connections	minimum pressure 0.05 MPa (0.5 bar)
	drum capacity 52 litres
Spin speed	up to 1200 rotations per minute
	Wash: programme 2; temperature
Energy rated	60°C; using a load of 7 kg.
	Drying: first drying cycle performed
programmes
	with a 2 kg load, by selecting the
according to
	drying level "A1" (IRON);
regulation
	Second drying cycle performed with a
EN 50229
	5 kg load, selecting the maximum
	drying level "A4" (EXTRA).
	This appliance conforms to the
	following EC Directives:
	- 89/336/EEC dated 03/05/89
	(Electromagnetic Compatibility) and
	subsequent modifications
	- 2006/95/EC (Low Voltage)
	- 2002/96/EC

3