Loading and using the dryer.
Always follow the fabric manufacturer’s care label when laundering.
Fabric Care Labels
Below are fabric care label “symbols” that affect the clothing you will be laundering.
Safety Instructions
WASH LABELS
DRY LABELS
Machine wash
cycle | Normal Permanent Press/ |
| Gentle/ |
| Hand wash | Do not wash | Do not wring |
| wrinkle resistant | delicate |
|
|
| ||
Water |
|
|
|
|
temperature | Hot |
| Warm | Cold/cool |
| (50°C/120°F) | (40°C/105°F) | (30°C/85°F) | |
|
|
|
| |
BLEACH LABELS |
|
|
| |
|
|
|
|
|
Bleach |
|
|
|
|
symbols Any bleach | Only |
|
|
|
(when needed) | (when needed) |
|
|
|
|
|
|
|
|
Tumble dry
DryNormal
Heat setting
HighMedium
Special instructions
Line dry/
hang to dry
|
|
|
| Do not dry |
Permanent Press/ | Gentle/ | Do not tumble dry | (used with | |
wrinkle resistant | delicate |
|
| do not wash) |
Low | No heat/air |
|
| |
Drip dry |
| Dry flat | In the shade | |
Operating
Sorting and Loading Hints
As a general rule, if clothes are sorted properly for the washer, they are sorted properly for the dryer. Try also to sort items according to size. For example, do not dry a sheet with socks or other small items.
Do not add fabric softener sheets once the load has become warm. They may cause fabric softener stains.
Bounce® Fabric Conditioner Dryer Sheets have been approved for use in all GE Dryers when used in accordance with the manufacturer’s instructions.
Do not overload. This wastes energy and causes wrinkling.
Do not dry the following items: fiberglass items, woolens,
Care and Cleaning of the Dryer
Instructions
Troubleshooting
The Exterior: Wipe or dust any spills or washing compounds with a damp cloth. Dryer control panel and finishes may be damaged by some laundry pretreatment soil and stain remover products. Apply these products away from the dryer. The fabric may then be washed and dried normally. Damage to your dryer caused by these products is not covered by your warranty.
The Lint Filter: Clean the lint filter before each use. Moisten your fingers and reach into the filter opening. Run your fingers across the filter. Have a qualified technician vacuum the lint from the dryer once a year.
The Exhaust Duct: Inspect and clean the exhaust ducting at least once a year to prevent clogging. A partially clogged exhaust can lengthen the drying time.
Follow these steps:
| Turn off electrical supply by disconnecting the |
1 | |
| plug from the wall socket. |
| Disconnect the duct from the dryer. |
2 | |
| Vacuum the duct with the hose attachment and |
3 | |
| reconnect the duct. |
The Exhaust Hood: Check with a mirror that the inside flaps of the hood move freely when operating. Make sure that there is not wildlife (birds, insects, etc.) nesting inside the duct or hood.
Tips
Customer Service
15