AKG Acoustics HT 4500 manual Safety and Environment, Safety Environment

Page 21

1 Safety and Environment

•Do not expose the equipment to direct sunlight, excessive dust, moisture, rain, me- chanical vibrations, or shock.

1.Be sure to dispose of used batteries as required by local waste disposal rules. Never throw batteries into a fire (risk of explosion) or garbage bin.

2.When scrapping the equipment, remove the batteries, separate the case, circuit boards, and cables, and dispose of all components in accordance with local waste disposal rules.

3.The packaging of the equipment is recyclable. Dispose of the packaging in an appropriate container provided by the local waste collection/recycling entity and observe all local legislation relating to waste disposal and recycling.

▲!

1.1Safety

1.2Environment

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 74 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa- tion. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interfer- ence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television recep- tion, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and the receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

Shielded cables and I/O cords must be used for this equipment to comply with the relevant FCC regulations.

Changes or modifications not expressly approved in writing by AKG Acoustics may void the user’s authority to operate this equipment.

HT 4500

21

Image 21

Contents D I E N U N G S a N L E I T U N G . . S Inhaltsverzeichnis Sicherheit und Umwelt Beschreibung Der MUTE-Schalter ist in allen Betriebsarten aktiv Des Handsenders ausAustauschbare Mikrofonköpfe Nicht mitgeliefert Siehe Fig Setup-Schalter kurz nach rechts oder links drehen Setup-Schalter kurz drücken Setup-Schalter lang drückenHinweis Symbole InbetriebnahmeElektronisch gegen Fehlbedienung gesichert sind Siehe Fig ModusHinweis Die Anzeige Mute nicht und die Kontroll-LED 1 leuchtet grünInbetriebnahme Inbetriebnahme Anzeige LOCK-Modus wieder einJeden Sender und Empfänger die Frequenz neu ein Geräuschen führenDen Wert 00 folgt die Anzeige Auto siehe Kapitel Schalter Den Setup-SchalterChe Wert in dB, die Anzeige Gain blinkt WiederholenBetriebshinweise Ten Sie den Setup-Schalter ca Sekunden lang gedrücktIm LOCK-Modus erscheint am Display die Anzeige Lock Schalter betätigenSenders. Die Kontroll-LED 1 wechselt auf grün MikrofonGramm unterhalb der Frequenzanzeige an Austauschen Die Beschallungsanlage wiedergegeben wird, zu gestaltenMehrkanalanlagen ReinigungBzw. den Akku BP 4000 aus dem Sender heraus Dass der Akku während des nächsten Auftritts leer wirdFehlermeldungen Fehlermeldung Behebung Err.JoG FehlermeldungenEinschalten SchaltenTechnische Daten TrägerfrequenzbereicheUnd 835-862 MHz Table of Contents Safety Environment Safety and EnvironmentDescription Parameter to be adjusted Battery capacity Measurement unitMute switch is active in all modes Currently active valueTures of these microphones StructionSetting Up Setting Up CeiverLit green Set will start flashing Local regulation authoritySetting Up Setting Up Push the setup switch briefly Quency for each transmiter and receiverWill be followed by Auto refer to section As follows UsingOperating Notes Ter. The status LED 1 will change to red Refer to fig Ter fader to reduce the volume and stop the howlingTransmitter. The status LED 1 will change to green Frequency readout Refer to figCleaning Error Messages Error Messages Power to transmitter onEst AKG Service Center 790-820, 835-862 MHz Carrier frequency rangesSommaire Sécurité et environnement Introduction Fournitures d’origine De commande Teur à mainPas le cas, veuillez contacter votre distributeur AKG ’émetteur à main dispose de trois modes de fonctionnementMain hors tension Cepteur lorsque le signal audio est sur muetON/OFF est en retrait Tion de la touche ON/OFF. La LED témoin 1 passe au vertEn mode Lock Mise en service Appuyer brièvement sur la moletteModes ’entrée voir point ’émetteur est alors en mode SilentLume Sélectionnée affichée en MHzMise en service Menu PresetsSi l’émetteur est sous tension, mettez-le hors tension Mise en service Mise en service Réglage de fréquence de chaque émetteur et chaque récepteur Multicanaux CepteurSecondes environ. L’écran affiche Appuyez un bref instant sur la moletteMise en service En mode LOCK, l’écran affiche Lock Mode LockUtilisation Menu Gain Gain d’entrée en dBMettez l’émetteur hors tension RemplacementMicrophone sur muet Tre de l’émetteur. La LED témoin 1 passe au vertNettoyage Messages d’erreur Messages d’erreur Plages de fréquences porteuses Caractéristiques techniquesIndice Sicurezza Ambiente Sicurezza e ambienteDescrizione Parametro da regolare Della batteria in oreDopo ca secondi il trasmettitore è pronto all’esercizio Smettitore manualeNiche Nel modo LockMessa in esercizio Premere a lungo l’interruttore SetupAvvertenza Simboli Importante Modi d’esercizioRadio Capitolo 3.6 e la sensibilità d’ingresso vedi capitoloSplay 2 si attiva Vedi figDisattivazione 1 Menù PresetPortante IntermodulazioneMessa in esercizio Guente indicazione Terebbe forti rumori disturbanti SceltoSinistra o a destra. Sul display viene visualizzato Save -n PeggiaLore originale in dB, l’indicazione Gain lampeggia CondiMente l’interruttore Setup Indicazioni per l’esercizioMenù batteria Capacità Disattivate il trasmettitore Solo diminuendo il volumeCome silenziare Smettitore. Il LED di controllo 1 cambia sul verdeImpianti pluri-canale PuliziaProssimo canale libero del gruppo di frequenze prescelto Quenza nuovaGetevi al vs. punto service Err.PrE Errori visualizzati sul display Errore Rimedio Err.rFSibile prescegliere un Preset Delle SetupErrore Rimedio Err.JoG Indicazioni erroriSinserire il trasmettitore e Reinserirlo dopo 10 secondi790-820 e 835-862 MHz Gamme delle frequenze portantiSeguridad y medio ambiente ÍndiceSeguridad Seguridad y medio ambienteBraciones o a golpes Medio ambienteIntroducción DescripciónMiento del transmisor manual Véase fig Elementos de mandoDe la pila en horas Dad de mediciónVéase . pondientes micrófonos Puesta en funcionamiento Sualizador 2 se encienda Ajustada actualmente en MHzEn verde Puesta en funcionamiento Puesta en funcionamiento Puesta en funcionamiento Cuencias seleccionado Mente la frecuencia para cada transmisor y receptorRuidos de interferencia Hable o cante frente al micrófono Instrucciones para el uso Sionado el conmutador Setup durante aprox segundosCapacidad de las pilas Conmutar entre los Manera involuntariaInstrucciones para el uso Limpieza Del transmisorLador durante un período mayor Avisos de error Avisos de error Gamas de frecuencias portadoras Datos técnicos102 101103 104Segurança Meio ambiente Segurança e meio ambienteDescrição Mente 7 segundos VoluntárioComutador Mute está ativo em todos os modos de operação Descrição Pítulo OperaçãoOperação Importante LigarPressione por ca ,6 segundos a tecla ON/OFF Desligar Trole SetupAjustar a freqüência PortadoraVeja capítulo 3.4.2 GinalGuinte indicação Pressione brevemente o controle Setup LecionadoCia novamente para cada emissor e receptor Fale ou cante no microfone Capacidade das pilhas Comutar entre os Instruções para o usoDe diagrama em barras Em forma de diagrama em barras AcumuladorDe volume menor LED de controle 1 muda para verdeLimpeza BP 4000 do emissorPróxima apresentação Indicações de falha Indicações de falha Problema Resolver o problema Rec.AccRegeneração Cional CUFaixas de freqüências portadoras EspecificaçõesNotizen Notes Notes Note Notas Notas 111 Page Page WL1 3700 WL1 3800 WL1 5900 WL1 535 WL1