Clarity XLC2 Battery Information, Amplifier settings used. Replace batteries every two years

XLC2 FeatureHandsetList & Overview -

10.TALK: Press TALK to start an outgoing phone call or to answer an incoming call.Also, press TALK when the handset is found (if the FIND function is activated from the base).The TALK button lights up as per the settings below:

•green when the phone is in use, non-Boost mode;

•red when the BOOST function is engaged;

•orange when the OSA function is active;

•blinks green during incoming ring or when the base is paging the handset (FIND function is engaged) - along with the visual ringer;

•blinks green (slower) during the memory programming process.

11.Dial Pad: Used to dial the phone numbers.The keys also serve as the location for 10 two-touch memory locations (see details under PROGRAMMING / DIALING MEMORY KEYS section - page 20).The dial pad is backlit for ease of use.

12.RD / P (Redial / Pause): When you hear the dial tone, press this button to redial the last number dialed (up to 32 digits). Press this button while programming the memory keys to insert a two second pause.

13.TONE Switch: Use this switch to pick one of the three tone settings available (see page 21).

14.NECKLOOP Port: Use a standard 3.5mm neckloop with your XLC2 handset. We recommend the Clarity CE30 Neckloop.

15.Headset Port: Use a standard 2.5mm plug headset with your XLC2 handset.We recommend the Plantronics M175C.

16.RINGER ON / OFF: Set this switch to OFF position if you want to turn off the handset ringer.

XLC2 Battery Information
	E
HANDSET	N
	G
The batteries in the handset must be fully charged for 10	L
	I
hours before using the telephone for the first time.
	S
Battery life: Talk time is 6.5 hours, while standby is 130	H
hours without usage.Actual times will vary depending on the
amplifier settings used. Replace batteries every two years.

Battery spec (as supplied with your phone): 3xAAA NiMH rechargeable batteries, (1.2V 600mAh NiMH, 60AAAHC, GPI International Ltd.).

To replace batteries, remove the handset battery cover and install new batteries, then close battery cover.

BASE (OPTIONAL)

The base batteries are optional (backup).You should use 3xAAA NiMH rechargeable batteries if you choose to put them in the base.The backup batteries should be AAA, NiMH, rechargeable only, rated 600mAh.

The base backup batteries ensure the functionality of your cordless phone (3-4 hours), in case of a power outage.

The batteries in the base must be fully charged for 10 hours. When the base unit operates in battery mode (no AC power). the base POWER light will blink once every two seconds.

To install batteries in the base:

1.Turn base over and remove memory card.

16 17