Cutting depth adjustment
•Remove battery pack.
•Loosen the depth adjustment nut and adjust the cutting depth, using the graduations on the lower guard to gauge the depth. Once finished
adjusting the depth, tighten the depth adjust- ment nut securely.
*When wood material is 10 mm (3/8") or less thick, adjust the cutting depth so that the blade protrudes approx. 5 mm (3/16") from the bottom of the material.
| Loosen | |
Depth | Tighten | |
adjustment | ||
| ||
nut | Pull down | |
|
Fig. 9
Rip fence (EY3500B7727)
(Available as an accessory, not included)
Rip fence is convenient for rip cuts and repeated cuts of uniform width.
•Remove battery pack.
•Insert rip fence and adjust cutting width. (See Fig. 10)
•Fasten screw securely to fix rip fence.
Insert and |
adjust |
Fasten screw |
Rip fence |
Fig. 10
Collecting Dust
WARNING
*Before cutting metal materials, always empty the dust case, open the front cover and remove the dust.
•Use the tool with the flammable materials in the dust case to cut metal materials may result in fire
*When cutting metal materials, always use the tool with the dust case attached.
•Flying sparks and metal chips may cause injury.
*Do not carry or store the battery pack in the same container as nails or similar metal objects.
(1)Collect dust in the dust case.
*Empty the dust case when it is filled up with dust.
*Empty the dust case before storing the tool.
*Dust case capacity
•When cutting electrical conduit with a diameter of 25 mm (1"), approximately 130 cuts
•When cutting 45 mm
NOTE:
Some materials may cause dust to become clogged inside the front cover when cutting those materials.
Front cover |
Fig. 11
(2)Use with vacuum cleaner to collect dust.
*Connect the tool to the hose using the EY9X012E vacuum cleaner hose adapter (sold separately).
Compatible hose inner diameter: 25 mm (1") to 38 mm
*Operate the vacuum cleaner obeying its instructions.
- 13 -