Panasonic EY4542 Maintenance, Transparent Guard, Cleaning Tool, Lamp Indications

Lamp Indications

Green Lit

Charger is plugged into the AC outlet.

Ready to charge.

Green Flashing Quickly

Charging is completed. (Full charge.)

Green Flashing

Battery is approximately 80% charged (Usable charge. Li-ion only).

Green Lit Now charging

Orange Lit

Battery pack is cool.

The battery pack is being charged slowly to reduce the load on the battery. (Li-ion only)

Orange Flashing

Battery pack is warm. Charging will begin when temperature of battery pack drops.

If the temperature of the battery pack is -10°C or less, the charging status lamp (orange) will also start flashing. Charg- ing will begin when the temperature of the battery pack goes up (Li-ion only).

Charging Status Lamp

Left: green Right: orange will be displayed.

Both Orange and Green Flashing Quickly
Charging is not possible. Clogged with dust or malfunction of
the battery pack.
X.MAINTENANCE	CAUTION:
	4. Remove the blade and brush off any dust.
	To avoid injury or damage to the unit, never
WARNING
To avoid severe personal injury, always remove	immerse any part of the tool in a liquid.
	Transparent Guard
the battery pack from the tool before starting any
maintenance procedure.
	WARNING
CAUTION:
	If the guard is cracked, or is broken, take the tool
To assure product SAFETY and RELIABILITY,	to an authorized service center for replacement.
servicing should be performed by an autho-	Do not attempt to operate tool. It could result in
rized service center. Always insist on genuine	serious personal injury.
Panasonic replacement parts.	Never use your tool with a damaged transparent
Cleaning Tool	guard or without the transparent guard installed.
	Flying chips could result in serious injury.
Keep your tool clean for good cutting perform-

ance, and to help keep it safe to use.

Follow these steps:

1.Remove the battery pack from the tool.

2.Wipe the tool with a dry, soft cloth. Do not use a wet cloth or cleaning liquids.

They could damage the tool’s finish.

3.Be sure to rub off any oil or grease which could make the tool slippery or hard to handle.

- 19 -