Panasonic EY7546 Battery Charger, Federal Communication Commission Interference Statement

Page 15

BATTERY CHARGER

Model		EY0L81
Electrical rating	See the rating plate on the bottom of the charger.
	EY9L41	EY9L42	EY9L44		EY9L50
Charging time	Usable: 45 min.	Usable: 30 min.	Usable: 50 min.
	Full: 60 min.	Full: 35 min.	Full: 65 min.

NOTE: This chart may include models that are not available in your area. Please refer to the latest general catalogue.

For the dealer name and address, please see the included warranty card.

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital de- vice, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turn- ing the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: To assure continued compliance, install and use in accordance with provided in- structions. Use only the battery pack specified in the instructions. Any changes or modifica- tions not expressly approved by the party responsible for compliance could void the user's au- thority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must ac- cept any interference received, including interference that may cause undesired operation.

This Class B digital apparatus complies with Canadian ICES-003.

Image 15

Contents Importante Model No EY7546/EY7547 EY7550/EY7551Index/Index/Indice Battery low warning lampGeneral Safety Rules Limited WarrantyDefinition of IP code Service II. Specific Safety RulesPower Tool Use and Care Battery Tool Use and CareBattery Pack Important Safety InstructionsSymbol Meaning Amperes AWG Size of Cord Equal to or But less Attaching or Removing Socket IV. AssemblyAttaching or Removing Battery Pack Attaching or Removing BitOperation Recommended work guideline table Control Panel 4Battery Pack For Appropriate Use of Bat tery Pack Battery Charger ChargingRecommended Grip Lamp Indications Bolt Tightening Conditions VI. MaintenanceVII. Tightening Torque Factors Affecting Tighten ing TorqueEY7550 VIII. Accessories SpecificationsIX. Appendix Federal Communication Commission Interference Statement Battery ChargerSécurité de la zone de travail Définitions des codes IPGarantie Limitée Conservez CES INSTRUC TionsSécurité personnelle Utilisation et soins de l’outil mécaniqueMaintenez les outils de coupe affûtés et propres Réparation Utilisation et soins de la batterie de l’outilSymbole Signification Instructions de sécurité importantesAvertissement Avertissement Fixation ou retrait de la batterie autonome IV. MontageFixation ou retrait d’une mèche Fixation ou retrait de la douilleCorps principal Comment utiliser le cro chet de ceintureUtilisation du commutateur pour une rotation en sens normal Tableau de référence des travaux recommandés Pour changer le côté d’installation du crochet de ceinturePanneau de commande Sélection du mode de puissance de percussionTenue recommandée BatterieBatterie autonome Li-ion Recyclage de la batterie autonome Chargeur de batterie RechargeMise EN Garde Longévité des batteries autonomesIndication DU Voyant Conditions de serrage des boulons EY7546 VI. EntretienVII. Couple DE SERRAGE Facteurs affectant le cou ple de serrageEY7551 EY7550Caracteristiques Techniques VIII. AccessoiresCapacites Maximum Recommandees IX. AppendiceEY9L44 EY9L50 Durée de chargement Batterie AutonomeSeguridad del lugar de trabajo Definición del código IPGarantía Limitada Guarde Estas INSTRUC CionesSeguridad personal Uso y cuidados de herramientas eléctricasMantenga las herramientas de corte afiladas y limpias Servicio Uso y cuidado de la herramienta a bateríaGuarde Estas Instrucciones LA BateriaInstrucciones de seguridad importantes ¡ADVERTENCIAAdvertencia Nota IV. MontajeColocación o extracción de la broca Instalación o desmontaje del cuboFuncionamiento del inter ruptor de rotación de avance FuncionamientoColocación y extracción de la batería Cuerpo principalSelección de modo de potencia de impacto Cómo utilizar el gancho del cinturónPara cambiar el lugar de ubicación del gancho de cinturón Panel de controleLuz LED Luz de advertencia de sobrecalenta mientoCuadro de guías de trabajo reco mendadas Vida útil de la batería Empuñadura recomendadaBloque de pilas Para un uso adecuado de la batería Batería de LiiónPrecaución Cargador de la batería CargaVI. Mantenimiento VII. PAR DE AprieteFactores que afectan al par de apriete Condiciones de apriete de pernos EY7546 M10 x 35 mm. M12, M14, M16 x 45 mm MPerno estándar kgf-cm VIII. Accesorios IX. AnexoEspecificaciones EY9L44 EY9L50 Tiempo de carga Cargador DE BateríaMemo Panasonic Consumer Electronics Company