Porter-Cable 1000003754 Motor Overload Protector not shown, How to Stop, Before Each Start-Up

Page 12

You know that the cooling system is working when air is being expelled.

Air Compressor Pump (not shown): Compresses air into the air tank. Working

air is not available until the compressor has raised the air tank pressure above that

required at the air outlet.

 

 

 

Drain Valve: The drain valve is located at the base of the

 

 

 

 

 

 

air tank and is used to drain condensation at the end of

 

 

 

each use.

 

 

 

 

Drain

 

Check Valve: When the air compressor is operating, the

 

 

 

Valve

 

check valve is "open", allowing compressed air to enter

 

 

 

 

 

 

the air tank. When the air compressor reaches "cut-out"

 

 

 

pressure, the check valve "closes", allowing air

 

 

 

 

 

 

 

 

pressure to remain inside the air tank.

 

 

 

 

Motor Overload Protector (not shown): The

 

 

 

 

motor has an automatic reset thermal overload

Check Valve

protector. If the motor overheats for any reason,

 

 

 

 

the overload protector will shut off the motor.

 

 

 

 

The motor must be allowed to cool down before

 

 

 

 

restarting. The compressor will automatically

 

 

 

 

restart after the motor cools.

 

 

 

 

HOW TO USE YOUR UNIT

How to Stop

1.Set the On/Off switch to "Off".

Before Starting

Do not operate this unit until you read and understand this instruction manual for safety, operation and maintenance instructions.

Break-in Procedure

Risk of Unsafe Operation. Serious damage may result if the following break-in instructions are not closely followed.

This procedure is required before the air compressor is put into service and when the check valve or a complete compressor pump has been replaced.

1.Make sure the On/Off switch is in the "Off" position.

2.Plug the power cord into the correct branch circuit receptacle. (Refer to Voltage and Circuit Protection paragraph in the Installation section of this manual.)

3.Open the drain valve (counter-clockwise) fully to permit air to escape and pre- vent air pressure build up in the air tank during the break-in period.

4.Move the On/Off switch to "On" position. The compressor will start.

5.Run the compressor for 15 minutes. Make sure the drain valve is open and there is minimal air pressure build-up in tank.

6.After 15 minutes, close the drain valve by turning clockwise. The air receiver will fill to "cut-out" pressure and the motor will stop.

The compressor is now ready for use.

Before Each Start-Up

1.Set the On/Off switch to "Off".

2.Turn the regulator knob counter-clockwise to set the outlet pressure to zero.

3.Attach hose and accessories.

Risk of unsafe operation. Firmly grasp air hose in hand when installing or disconnecting to prevent hose whip.

Risk of unsafe operation. Do not use damaged or worn

1000003754

12 - ENG

Image 12
Contents C2005 Safety Guidelines Definitions Important Safety InstructionsWhat can Happen HOW to Prevent IT HazardRisk to Breathing Asphyxiation Attachments & accessories Risk of BurstingRisk of Electrical Shock Electrical Grounding FailureRisk from Flying Objects Risk of HOT Surfaces What can Happen HOW to Prevent IT Risk from Moving PartsRisk of Unsafe Operation What can Happen HOW to Prevent IT Risk of FallingRisk from Noise Specifications AccessoriesGlossary Duty CycleAssembly InstallationHOW to SET UP Your Unit Grounding InstructionsExtension Cords Voltage and Circuit ProtectionOperation Know Your AIR CompressorDescription of Operation How to Stop Motor Overload Protector not shownBefore Each Start-Up Maintenance To Check Safety ValveHow to Start Customer ResponsibilitiesService and Adjustments To Replace or Clean Check ValveTo Drain Tank To Replace Regulator Service StorageTroubleshooting Problem Cause CorrectionProblem Cause Correction Problem Cause Correction Full ONE Year Warranty Incorrect USE can Cause HAZARDS. Follow These InstructionsMesures DE Sécurité Définitions Consignes DE Sécurité ImportantesÉvité, pourrait causer de graves Blessures ou la mort Dommages à la propriétéRisque D’EXPLOSION OU D’INCENDIE Ce qui peut se produire Comment l’ÉviterRisque D’ÉCLATEMENT CE QUI Peut SE Produire Comment L’ÉVITERAccessoires PneusRisque DE Choc Électrique Mise à la terre électrique le fait deDirectives relatives à la mise à la Risque Associé AUX Pièces MobilesRisque DE Chute Lexique Risque Associé AU BruitModèle no C2005 Cycle DE Service AccessoiresAssemblage Montage DE LappareilRallonges Protection Contre LA Surtension ET Protection DU CircuitUtilisation FAMILIARISEZ-VOUS Avec Votre Compresseur DairDescription DU Fonctionnement Utilisation DE Lappareil Arrêt de lappareilAvant chaque mise en marche Mise en marcheEntretien Responsabilités DU ClientVérification DE LA Soupape DE Sûreté Vidange DU RéservoirRemplacement OU Nettoyage DE LA Soupape DE Retenue Pour Remplacer LE Régulateu Rangement Pièces DE RechangeEntretien ET Réparation Dépannage Problème Cause CorrectionRemarque Ajustez Fusibles et remplacez-le Garantie Complète D’UN 1 AN Definiciones DE Normas DE Seguridad Instrucciones Importantes DE SeguridadMenores o moderadas Lesiones seriasPeligro Riesgo DE Explosión ¿QUÉ Puede SUCEDER? Cómo EvitarloElementos y accesorios NeumáticosRiesgo DE Objetos Despedidos Riesgo POR Piezas Móviles Riesgo DE Caídas ¿QUÉ Puede SUCEDER? Cómo Evitarlo Riesgo POR Ruidos ¿QUÉ Puede SUCEDER? Cómo EvitarloCuadro DE Especificaciones GlosarioCiclo DE Servicio Modelo Nº C2005Ensamblaje InstalaciónDesempaque Ubicación DEL Compresor DE AireCables DE Extensión Eléctrica Protección DEL Voltaje Y DEL CircuitoOperación Conozca SU Compresor DE AireDescripción DE Operaciones Cómo Utilizar SU Unidad Cómo detenerlaMantenimiento Responsabilidades DEL ClienteAntes de cada puesta en marcha Cómo poner en marchaCómo Verificar LA Válvula DE Seguridad Cómo Drenar EL TanqueServicio Y Ajustes Para Reemplazar O Limpiar LA Válvula RetenciónPara Reemplazar EL Regulador Almacenaje ServicioPiezas DE Repuesto Mantenimiento Y ReparacionesGuía DE Diagnóstico DE Problemas Problema CausaAccesorios CorrecciónUsando el accesorio El motor no funciona Fusible fundido inter Garantía Completa DE UN AÑO 1000003754 Deltaportercable.com