Laser Accessories, Digital Laser Detector DW0772

English

5.Turn the Rack ‘N Pinion adjustment knob (L) located to the right of the wall mount to move the laser level up and down to set your height. Use the wall mount measuring scale to pinpoint your mark.

NOTE: It may be helpful to turn the power on and turn the rotary head so that it puts a dot on one of the laser scales. The DEWALT target card is marked at 1-1/2" (38mm), therefore, it may be easiest to set the offset of the laser to 1-1/2" (38mm) below the wall angle.

6.	Once you have positioned the
	laser at the desired offset height,
	tighten the Rack ‘N Pinion
	locking knob to maintain the
	offset.
7.	Using the base leveling knob
	(M), approximate a level position	M
	from the wall.

Laser Accessories

Recommended accessories for use with your tool are available for purchase at your factory-owned local service center.

CAUTION: The use of any non-recommended accessory may be hazardous. Use only DEWALT accessories designed for use with this product.

If you need any assistance in locating any accessory, please con- tact DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286 or call 1-800-4-DEWALT (1-800-433-9258). See our catalog on the World Wide Web at www.dewalt.com.

Digital Laser Detector: DW0772

Some laser kits include a DEWALT digital laser detector. The DEWALT digital laser detector allows you to locate a laser beam emitted by a rotary laser in bright light conditions or over long dis- tances. The detector can be used in both indoor and outdoor situ- ations where it is difficult to see the laser beam. The detector is not

for use with non-rotating lasers but is compatible with most rotary red-beam or infra-red (invisible) beam lasers on the market. It can be set to indicate the location of the beam to either the nearest 1/8" or the nearest 1/25". The detector gives both visual signals through the display window (N) and audio signals through the speaker (O) to indicate the location of the laser beam.

The DEWALT digital laser detector can be used with or without the detector clamp. When used with the clamp, the detector can be positioned on a grade rod, leveling pole, stud or post.

BATTERIES

The digital laser detector is powered by a 9 volt battery. To install the battery provided, lift up on the battery compartment cover (P). Place the 9 volt battery in the compartment, aligning the battery as shown on the embossed icon (Q).

DETECTOR CONTROLS

The detector is controlled by the power/volume button (R) and the accuracy mode button (S). When the power/volume button is pushed once, the detector is turned on. The top of the display win-