Delta 46-455, 46-460ST Starting And Stopping Lathe, LOCKING SWITCH in THE OFF POSITION

STARTING AND STOPPING LATHE

To reduce the risk of injury, make sure that the ON/OFF switch is in the "OFF" position before plugging cord into outlet. Do not touch the plug’s metal prongs when unplugging or plugging in the cord.

To turn lathe on, lift switch paddle (JJ) Fig. 22 up to the "ON" position. To turn lathe off, push switch paddle down

to the "OFF" position

LOCKING SWITCH IN THE "OFF" POSITION

To reduce the risk of injury, in the event of a power outage (such as a breaker or fuse trip), always move the switch to the “OFF” position until the main power is restored.

IMPORTANT: When the machine is not in use, the switch should be locked in the "OFF" position to prevent unauthorized use, using a padlock (KK) Fig. 23 with a 1/4" (6.4 mm) diameter shackle.

MOTOR OVERLOAD PROTECTOR

The tool is equipped with a manual reset circuit breaker. If the tool is overloaded or stalled too long the circuit breaker will trip causing the tool to shut off.

To restart:

1.Set the ON/OFF switch to "OFF"

2.Allow the motor to cool 3-5 minutes.

3.Press the reset button (LL) Fig. 24.

4.Resume normal operations.

JJ

Fig. 22

KK

Fig. 23

LL

Fig. 24

13