Delta 46-455, 46-460ST instruction manual Functional Description, Carton Contents

EXTENSION CORDS

Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord which has a 3-prong grounding type plug and matching receptacle which will accept the machine’s plug. When using an extension cord, be sure to use one heavy enough to carry the current of the machine. An undersized cord will cause a drop in line voltage, resulting in loss of power and overheating. Fig. D-1 shows the correct gauge to use depending on the cord length. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.

MINIMUM GAUGE EXTENSION CORD

RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC MACHINES

		Total
Ampere		Length of
		Cord in	Gauge of Extension
Rating	Volts	Feet	Cord
0-6	120	up to 25	18 AWG
0-6	120	25-50	16 AWG
0-6	120	50-100	16 AWG
0-6	120	100-150	14 AWG
6-10	120	up to 25	18 AWG
6-10	120	25-50	16 AWG
6-10	120	50-100	14 AWG
6-10	120	100-150	12 AWG
10-12	120	up to 25	16 AWG
10-12	120	25-50	16 AWG
10-12	120	50-100	14 AWG
10-12	120	100-150	12 AWG
12-16	120	up to 25	14 AWG
12-16	120	25-50	12 AWG
12-16	120	GREATER THAN 50 FEET NOT RECOMMENDED

Fig. D-1

FUNCTIONAL DESCRIPTION

FOREWORD

DELTA® Midi-Lathe46-460:Electronic variable speed lathe with a 1 HP Max motor that can turn objects at any speed between 250 and 4,000 RPMs.

DELTA® Midi-Lathe46-455: Manual 5-speed lathe with a 3/4 HP Max that can turn objects at five different speeds, from 500 RPM to 4,000 RPM.

Both lathes will turn objects up to 12-1/2" (318 mm) in diameter over the bed and 9" (229 mm) in diameter over the tool rest base. The maximum distance between centers is 16-1/2" (419 mm).

NOTICE: The manual cover illustrates the current production model. All other illustrations contained in the manual are representative only and may not depict the actual labeling or accessories included. These are intended to illustrate technique only.

CARTON CONTENTS

A.	Faceplate	A
			D
B.	Tailstock
C.	Tool rest base
D.	6 in. (152 mm) tool rest
E.	Hex wrench 3 mm
				B
F.	Live center
G.	Spur center
H.	Knockout bar
I.	Faceplate wrench
J.	10 in. (254 mm) tool rest

C

J

		G
E
				I
	F		H

6