Black & Decker BDCD220RS Important Safety Instruction for Battery Packs, Read all Instructions

Page 6

foreign material. Foreign materials of a conductive nature such as, but not limited to, steel wool, aluminum foil, or any buildup of metallic particles should be kept away from charger cavities. Always unplug the charger from the power supply when there is no battery pack in the cavity. Unplug charger before attempting to clean.

DO NOT attempt to charge the battery pack with any chargers other than the ones in this manual. The charger and battery pack are specifically designed to work together.

These chargers are not intended for any uses other than charging designated Black & Decker rechargeable batteries. Any other uses may result in risk of fire, electric shock or electrocution.

Do not expose charger to rain or snow.

Pull by plug rather than cord when disconnecting charger. This will reduce risk of damage to electric plug and cord.

• Make sure that cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.

• Do not use an extension cord unless it is absolutely necessary. Use of improper extension cord could result in risk of fire, electric shock, or electrocution.

• An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety. The smaller the gauge number of the wire, the greater the capacity of the cable, that is 16 gauge has more capacity than 18 gauge. When using more than one extension to make up the total length, be sure each individual extension contains at least the minimum wire size.

Do not place any object on top of charger or place the charger on a soft surface that might block the ventilation slots and result in excessive internal heat. Place the charger in a position away from any heat source. The charger is ventilated through slots in the top and the bottom of the housing.

Do not mount charger on wall or permanently affix charger to any surface. The charger is intended to use on a flat, stable surface (i.e., table top, bench top).

Do not operate charger with damaged cord or plug — have them replaced immediately.

Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way. Take it to an authorized service center.

Do not disassemble charger; take it to an authorized service center when service or repair is required. Incorrect reassembly may result in a risk of electric shock, electrocution or fire.

Disconnect the charger from the outlet before attempting any cleaning. This will reduce the risk of electric shock. Removing the battery pack will not reduce this risk.

NEVER attempt to connect 2 chargers together.

The charger is designed to operate on standard household electrical power (120 Volts). Do not attempt to use it on any other voltage.

SAVE THESE INSTRUCTIONS

Important Safety Instruction for Battery Packs

WARNING: For safe operation, read this manual and manuals originally supplied with tool before using the charger.

The battery pack is not fully charged out of the carton. Before using the battery pack and charger, read the safety instructions below. Then follow charging procedures outlined.

Read all Instructions

Do not incinerate the battery pack even if it is severely damaged or is completely worn out. The battery pack can explode in a fire. Toxic fumes and materials are created when battery packs are burned.

Do not charge or use battery in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Inserting or removing the battery from the charger may ignite the dust or fumes.

If battery contents come into contact with the skin, immediately wash area with mild soap and water. If battery liquid gets into the eye, rinse water over the open eye for 15 minutes or until irritation ceases. If medical attention is needed, the battery electrolyte for Lithium-Ion batteries is composed of a mixture of liquid organic carbonates and lithium salts.

Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persist, seek medical attention.

WARNING: Burn hazard. Battery liquid may be flammable if exposed to spark or flame.

Charge the battery packs only in Black & Decker chargers.

DO NOT splash or immerse in water or other liquids. This may cause premature cell failure.

Do not store or use the tool and battery pack in locations where the temperature may reach or exceed 105°F (40˚C) (such as outside sheds or metal buildings in summer). WARNING: Never attempt to open the battery pack for any reason. If battery pack case is cracked or damaged, do not insert into charger. Do not crush, drop or damage battery pack. Do not use a battery pack or charger that has received a sharp blow, been dropped, run over or damaged in any way (i.e., pierced with a nail, hit with a hammer, stepped on). Damaged battery packs should be returned to service center for recycling.

6

Image 6
Contents 20v max* reciprocating saw Page Work Area Safety  Electrical safetySave all warnings and instructions for future reference Specific Safety Rules Use power tools only withImportant Safety Instructions for Battery Chargers SymbolsImportant Safety Instruction for Battery Packs Charge the battery packs only in Black & Decker chargersRead all Instructions Installation and Removal of the Battery Pack To remove blade from saw Blade Clamp release lever To install blade into sawOperating Instructions Flush Cutting Figure GAccessories TroubleshootingMaintenance PROJECT TIPSBattery Service Information Limited Two-Year Home Use WarrantyLatin America This warranty Rbrc SealScie alternative de 20 V MAX Page Avertissement Consignes de sécurité particulièresAvertissement Toujours Avertissement certainsConserver CES Directives Avertissement pour un Lire toutes les directivesAvertissement risque Recommandations en matière de rangementAvertissement ne jamais Procédure de chargeFonctionnement Avertissement toujours DétenteConseils Pour LES Projets Lubrification Problème Cause possible Solution possibleDépannage Maximiser la durée de vie duEntretien Le sceau RbrcInformation sur les réparations Pautas DE SEGURIDAD/DEFINICIONES Chispas que pueden encender el polvo o los vaporesSeguridad eléctrica Seguridad personal Expuestas de la herramienta eléctrica Muchos accidentes a causa de lasProvocar que las partes metálicas Propensas a trabarse y son másAdvertencia El uso de esta Advertencia Riesgo dePrecaución Riesgo de Advertencia Peligro de Advertencia Para unLea todas las instrucciones Advertencia Nunca intenteRecomendaciones Con respecto al Almacenamiento Procedimiento de cargaNotas importantes sobre la carga Advertencia Utilice siempre la Instrucciones de operaciónPalanca de liberación de la abrazadera de la hoja Además de daños en la zapata y en la pieza de trabajoSugerencias Para EL Proyecto LubricaciónAccesorios Detección de problemasMantenimiento Advertencia El uso deGarantía limitado de dos años para uso en el hogar El sello RbrcInformación de mantenimiento América Latina esta garantía noAños DE Garantia Esta Garantia no Aplica CuandoSolamente Para Propositos DE Mexico 20V MAX* Cordless Drill Catalog NumberGeneral Power Tool Safety Warnings Page Ansi Z87.1 eye protection CAN/CSA Z94.3 Volts Hertz WattsImportant Safety Instructions for Battery Functional DescriptionChargers Importantsafety Instruction for Batterypacks Total Length of CordSummer Recycling Pattern indicated on the labelSafety Warnings and Instructions Drills Installing and Removing the Battery Pack from the ToolOperating Instructions Trigger Switch & Reversing Button Figure DBefore installing or removing accessories Torque Control Figure EOn Board BIT Storage Figure H Dual Range Gearing Figure GScrew Driving DrillingDrilling in Metal TroubleshootingMaintenance Drilling in MasonryService Information Full TWO-YEAR Home USE Warranty Mode DʼEMPLOI DE LA Perceuse Sans FIL DE 16V MAX*, 20V MAX Page Deélectriquelʼoutil électrique ContrôlerExposition au bruit peut entraîner une perte auditive Ins médicaux Le liquide qui gicleUtilisation sécuritaire de lʼoutil électrique Peut entraîner des blessures corporellesAmpères Tours à la minuteOu une électrocution Guirlande. Cela permet de réduire le risqueDʼendommager la fiche ou le cordondʼalimentation D. un dessus de table ou dʼétabli Remplacer immédiatementConsignes de chargement décrites Risques de choc électrique, dʼélectrocution ou dʼincendieManuels fournis avec lʼoutil avant dʼutiliser le chargeur Sont dégagées lorsque les blocs-piles sont incinérésProcédure DE Charge Recommandations EN Matière DE RangementFonctions DE Diagnostic DU Chargeur Pile EN Mauvais ÉtatInsertion DU BLOC-PILES Insérer le bloc-piles Ne jamais ouvrir le bloc-piles pourInsertion ET Retrait DU BLOC-PILES DE LʼOUTIL Retrait DU BLOC-PILES Enfoncer le bouton deDétente ET Bouton Inverseur Figure D Réglage DU Couple Figure EMandrin Sans CLÉ Figure F Perçage VissageRangement Intégré DES Mèches Figure H Perçage DU BoisDépannage Perçage DE LA MaçonnerieProblème MaximiserladuréedevieduInformation SUR LES Réparations Manual DE Instrucciones DEL Taladro Inalámbrico DE 20V MÁX LDX120Catálogo NPautas DE SEGURIDAD/DEFINICIONES Mantenimiento adecuado.Las herramientas de Uso y mantenimiento de la herramienta con bateríasPuede ocasionar la pérdida de la audición Quemadurasterminal al otroo incendioGarantizará la seguridad de la herramienta eléctrica Control podría ocasionar lesiones personalesTerminales de conexión a tierre Símbolo de alertaElectrocución Riesgo de descarga eléctrica, electrocución o incendioCargue los paquetes de baterías sólo con cargadoresde Recomendaciones CON Respecto AL AlmacenamientoProcedimiento DE Carga Retraso POR Paquete CALIENTE/FRÍO Diagnóstico DEL CargadorBatería EN MAL Estado Dejar LA Batería EN EL CargadorPara Extraer EL Paquete DE Baterías Instrucciones DE OperaciónPara Instalar EL Paquete DE Baterías Interruptor Disparador Y Botón DE Inversión Figura DAdvertencia Asegúrese de que el botón Ajuste DEL Control DE Torsión Figura EPortabrocas SIN Llave Figura F AccesoriosTaladrado DestornilladoEspacio EN LA Herramienta Para Guardar Brocas Figura H Taladrado EN MaderaMaximizarlavidaútildel Detección DE ProblemasCausa posible Ayuda Black & Decker al 01 800 847 2309/01 800 847Page Product Infomation · Identificación DEL Producto Años DE GarantiaPara Servicio y ventas