Black & Decker BDPS400K, BDPS600K instruction manual Cleaning the Direct to can Hose

• Remove the piston and spring (figure P7).

P6

P7

• Clean the spray nozzle, pickup tube and filter,

atomizer, piston and spring with the cleaning

brush in the appropriate cleaning solution

(figure P8).

• Thoroughly clean the inside of the piston

chamber with the cleaning brush (figure P9).

IMPORTANT: Be sure to remove all material

from inside of piston chamber. A small amount

of material that is not removed with the cleaning

brush can harden over time and interfere with

the movement of the piston causing damage to

the sprayer.

Ensure that quick clean knob is oriented in the spray position as shown in figure P10 with an arrow.

• Thoroughly clean the inside of the intake and return openings with the cleaning brush (figure P10).

IMPORTANT: Also thoroughly clean the smaller vent hole, shown with an arrow in figure P11, with included cleaning pin.

• Dry all parts thoroughly.

CLEANING THE DIRECT TO CAN HOSE:

• Unplug the sprayer from the power source.

• Remove the suction tube from the material container and submerge into a bucket containing solvent appropriate to the type of material you sprayed (warm, soapy water for latex-based materials; manufacturers recommended cleaning solution for oil based materials (figure Q).

• Plug in sprayer. Point sprayer into the side of another waste container. Trigger the sprayer until the spray pattern turns to only the color of the cleaning solution (figure Q1).

Q Q1

14