![](/images/new-backgrounds/1333020/33302055x1.webp)
My HP Brio Doesn’t Start Properly
The PC Hangs and Emits Beeps During Startup
These beeps indicate errors in the very early stages of the boot sequence (refer to page 35)
Have you checked that ... |
| How |
|
Your memory modules are of the correct type | Ö | 1 | Disconnect the PC’s power cord. |
| 2 | Remove the PC’s main cover and lift out the power | |
|
| 3 | supply (see page 51). |
|
| Replace the memory module with a known working | |
|
| 4 | memory module (see page 65). |
|
| Reconnect the PC’s power cord and start up the PC. | |
The expansion card you have installed is | Ö | 1 | Disconnect the PC’s power cord. |
compatible | 2 | Remove the PC’s main cover (see page 49). | |
|
| 3 | Remove the expansion card (see page 66). |
|
| 4 | Reconnect the PC’s power cord and start up the PC. |
That you have not made any changes to the PC’s Setup program that may be causing the
problem
Ö 1 Enter the Setup program by pressing F2 when prompted during startup. Refer to page 72.
2 Reload the default Setup values by pressing F9. 3 Press F10 to exit Setup saving changes.
If the problem persists, contact your authorized support provider
You Get a
Have you checked that ... | How |
You didn’t leave a
The device boot order is correct in the Setup program
Ö1 Check for a
2Remove the floppy disk if there is one in the drive.
3Restart the PC.
Ö1 Enter the Setup program by pressing F2 when prompted during startup. Refer to page 72.
2Reload the default Setup values by pressing F9.
3Press F10 to exit Setup saving changes.
The Power-On Self Test Detects an Error
An
Have you checked... | How |
The part of your configuration with which the
If you still have a problem
Ö
Ö
For more specific troubleshooting information, refer to “My HP Brio Detects an Error at Startup” on page 35
Run HP
20