My HP Brio Detects an Error at Startup
Serial or Parallel Port Test Error
Have you checked that...
The port is correctly configured in the PC’s | Ö |
Setup program |
You have not connected a device incorrectly | Ö |
or forgotten to switch it on | |
You have installed the correct device drivers | Ö |
There is not a hardware problem | Ö |
You are using the latest BIOS for your PC | Ö |
If the problem persists, contact your authorized support provider
Other Configuration Problems
How
1Switch the PC OFF then ON.
2When the message Press F2 to Enter Setup appears, press the F2 key. Refer to page 72.
3Check the port is enabled and the correct setting is selected under I/O Device Configuration in the Advanced menu.
1Switch off the PC.
2Plug the cables into the correct connectors on the back of the PC.
3Switch on the PC and the external devices.
Refer to the documentation for your serial or parallel device.
Run
Download the latest BIOS and instructions for its installation from HP’s Web at:
www.hp.com/go/briosupport
If the POST produces an error not covered in this section...
Have you checked that...
The Setup program settings are correct
You are using the latest BIOS for your PC
Ö
Ö
How
1Turn on or restart the PC.
2When the message Press F2 to Enter Setup appears, press the F2 key. Refer to page 72 for more information.
Download the latest BIOS and instructions for its installation from HP’s Web at:
www.hp.com/go/briosupport
40