Jenn-Air SLIDE-IN RANGE important safety instructions Troubleshooting, Problem Solution

TROUBLESHOOTING

PROBLEM	SOLUTION
For most concerns, try these first.	• Check if oven controls have been properly set.
	• Check to be sure plug is securely inserted into receptacle.
	• Check or re-set circuit breaker. Check or replace fuse.
	•	Check power supply.
Part or all of appliance does not	• Check if surface and/or oven controls have been properly set. See pgs. 12 & 16.
work.	•	Check if oven door is unlocked after self-clean cycle. See pg. 6.
	• Check if oven is set for a delayed cook or clean program. See pgs. 16 & 5.
	• Check if control lock is activated. See pg. 15.
	• Check if control is in Sabbath Mode. See pg. 27.
Clock, indicator words, and/or	• Oven may be set for a Cook & Hold or delay function.
lights operate but oven does	• Control lock may have been set. See pg. 15.
not heat.
Surface burner fails to light.	• Check to be sure unit is properly connected to power supply.
	• Check for a blown circuit fuse or a tripped main circuit breaker.
	• Check to be sure ignitor is dry and clicking. Burner will not light if ignitor is damaged,
		soiled or wet. If ignitor doesn’t click, turn control knob OFF.
The flame is uneven.	• Burner ports may be clogged.
Surface burner flame lifts	• Check to be sure a pan is sitting on the grate above.
off ports.
Baking results are not as	• Check the oven temperature selected. Make sure oven is preheated when recipe
expected or differ from		or directions recommend preheat.
previous oven.	•	Make sure the oven vent has not been blocked. See page 20 for location.
	• Check to make sure range is level.
	• Temperatures often vary between a new oven and an old one. As ovens age, the oven
		temperature often “drifts” and may become hotter or cooler. See page 27 for
		instructions on adjusting the oven temperature. Important: It is not recommended
		to adjust the temperature if only one or two recipes are in question.
	• Use correct pan. Dark pans produce dark browning. Shiny pans produce light
		browning.
	• Check rack positions and pan placement. Stagger pans when using two racks. Allow
		1-2 inches between pans and oven wall.
	• Check the use of foil in the oven. Never use foil to cover an entire oven rack. Place
		a small piece of foil on the rack below the pan to catch spillovers.
Food is not broiling properly or	• Check oven rack positions. Food may be too close to flame.
smokes excessively.	• Aluminum foil was incorrectly used. Never line the broiler insert with foil.
	• Trim excess fat from meat before broiling.
	• A soiled broiler pan was used.
	• Preheat oven for 2-3 minutes before placing food in the oven.
	• Broil with the oven door closed.
		Cont.

10