3-12. DAILY FILTERING (Continued)
Figure 3
Figure 4
Model EEG-141, 142, 143, 144
7. Scrape or brush the sides and the bottom of the vat. Be careful not to damage the sensing probes.
Do not use steel wool, other abrasive cleaners or cleaners/ sanitizers containing chlorine, bromine, iodine or ammonia chemicals, as these will deteriorate the stainless steel material and shorten the life of the unit.
Do not use a water jet (pressure sprayer) to clean the unit, or component damage could result.
8. Once the vat is clean and the display shows
“SCRUB VAT COMPLETE?” “YES NO”. Press √ button for YES and the display shows “WASH VAT” “YES NO”.
9. Press √ button and display shows “WASHING”. The oil circu- lates through the vat for several minutes. Once the wash cycle is complete, display shows “WASH AGAIN?” “YES NO”.
10. Press X√ button for YES if another wash is needed, otherwise press button for NO and the display shows “CLOSE DRAIN”
11. Once the vat is filled, “OPEN DRAIN” shows in display. Pull- out on drain knob to open the drain (Figure 4) and display shows “RINSING”. When rinsing is complete, display shows “RINSE AGAIN?” “YES NO”.
12. Press X√ button for YES if another rinse is needed, otherwise press button for NO. The display shows “POLISH?” “YES”.
13. Press √ button for YES and the oil is “polished” by circulating it through the filtering systemX. The display shows “5:00 STOP POLISH”. If desired, press button to stop the polishing, otherwise the oil is polished for 5 minutes.
14. Once the oil is polished, the display shows “FILL VAT?” “YES”. Press √ button and display shows “CLOSE DRAIN”.
15. Once full, the display shows “IS POT FILLED?” “YES NO”. Press √ button for YES and fryer returns to normal operation.
If X button is pressed, the display shows “FILLING”. You can try to fill the vat 4 times and then the control shows “ADD QUIT”. Press √ button and JIBX pump runs 60 seconds, filling the vat from the JIB. Press button and controls return to
809
normal operation.