|
|
| Model | |
|
|
| ||
(Continued) |
|
|
|
|
|
|
|
|
|
Problem | Cause |
| Correction | |
Oil foaming or boiling | • Water in oil | • | Drain and clean oil | |
over top of vat | • Improper or bad oil | • Use recommended oil | ||
| • Improper filtering | • | Refer to filtering procedures | |
| • Improper rinsing after | • Clean and rinse vat and then | ||
| cleaning the vat |
| dry thoroughly | |
|
|
|
| |
Oil will not | • Drain valve clogged | • Open valve, force cleaning brush | ||
drain from vat | with crumbs |
| through drain | |
| • Drain trough clogged | • Remove right side panel and remove | ||
|
|
| plug from end of trough and clean | |
|
|
| trough | |
|
|
|
| |
Filter motor runs but | • Filter line connections loose | • Tighten all filter line connections | ||
pumps oil slowly | • Filter paper or pad |
|
|
|
| clogged | • Change filter paper or pad | ||
| • Filter not reassembled | • | Refer to assembly instructions on inside | |
| correctly |
| of door | |
|
|
|
|
|
Bubbles in oil during | • Filter pan not completely | • | Make sure filter pan return line is | |
entire filtering process | engaged |
| pushed completely into the receiver on | |
| • Filter pan clogged |
| the fryer | |
| • Clean pan and change paper or pad | |||
| • Damaged | • Change | ||
| line receiver on fryer |
|
|
|
|
|
|
| |
Filter motor will not run | • the thermal reset button on | • Remove the right side panel and | ||
| the rear of the pump motor |
| allow time for the motor to cool | |
| is tripped |
| and then, using a screwdriver, | |
|
|
| press hard against the button | |
|
|
| until it clicks |
To prevent burns caused by splashing shortening, turn the unit's POWER switch to the OFF position before resetting the filter pump motor’s manual reset protection device.
609 |