5-1. MODIFYING PRODUCT SETTINGS (Continued)
609
Model EEG-141, 142, 143, 144
To Change Times and Temperatures
7. Press button until “COOK TIME” shows in the display, and then use the product buttons, or the
and 
buttons, to change the time in minutes and seconds, to a maximum of 59:59.
8.Press button and “TEMP” shows in the display, along with the preset temperature on the right side of the display.
Press the product buttons, or the
and 
buttons, to change the temperature. The temperature range is 190°F (88°C) to 375°F (191°C).
Cook ID Change
9.Press 
button until “COOK ID” shows in the display along with the product ID. For example, NUG would be the
ID for nuggets. Use the product buttons, or the 
and 
buttons, to change the ID.
Alarms (1 & 2)
11. Press button until “ALRM 1” shows in the left display, and an alarm time in the right display. Press the product buttons,
or the 
and 
buttons, to set an alarm.
Ex., If a Cook Cycle was set at 3 minutes, and an alarm was to go off after 30 seconds into the Cook Cycle, “2:30” would be set in the display at this time. When the timer counts down to 2:30 the alarm sounds.
After the alarm time is set, press 
button and “ALRM 2” shows in the display, and a second alarm can be programmed.
Quality Timer (hold time)
12. Press 
button until “QUAL TMR” shows in the display along with the preset holding time. Press the product buttons,
or the 
and 
buttons,to adjust holding time, up to 59:59.
GlobalIncludeFinlterFilterTrackingCount
13a. Press 
button until “INCL IN FLTR CNT” flashes in the display along with “YES” or “NO”. Using
and
buttons, change the display to “YES” if that product’s Cook Cycles are to be counted as part of the recommended filter process. Set to “NO” if it is not to be included.