Panasonic DW10000U manual Connection, Before starting connection, Outside view Pin No, Sync/Y

Connection

Before starting connection

•Before connection, read carefully the instruction manual for the device to be connected.

•Turning off the power switch of the devices before connecting cables.

•If any connection cable is not supplied with the device, or if no optional cable is available for connection of the device, prepare a necessary system connection cable to suit the device.

•Video signals containing too much jitter may cause the images on the screen to randomly wobble or wafture. In this case, a time base corrector (TBC) must be connected.

•The projector accepts the following signals: video, S-Video, analog RGB, DVI-D and signals which are compatible with the optional input module (p. 27).

•Some PC models cannot be connected to the projector.

●The pin-out and signal names of the S-VIDEO IN terminal are shown in the diagram below.

Outside view

Pin No. Signal

#Ground (luminance signal) $ Ground (color signal)

% Luminance signal & Color signal

●The pin-out and signal names of the RGB2 IN terminal are shown in the diagram below.

Outside view

Pin No. Signal

#R/PR

$ G/G • SYNC/Y

%B/PB

1HD/SYNC

2VD

&, -,0, and 3 are not assigned. ( - +, . and / are GND terminals.

●The pin-out and signal names of the DVI-D IN terminal are shown in the diagram below.

=5

4-

+#

Outside view

Pin	Signal	Pin	Signal
No.		No.
#	T.M.D.S data 2–	1
$	T.M.D.S data 2+	2	+5V
%	T.M.D.S data 2 / 4 shield	3	Ground
		4	Hot plug detection
&		5	T.M.D.S data 0-
(		6	T.M.D.S data 0+
)	DDC clock	7	T.M.D.S data 0 / 5 shield
*	DDC data
+		8
-	T.M.D.S data 1–	9
.	T.M.D.S data 1+	:	T.M.D.S clock shield
/	T.M.D.S data 1 / 3 shield	;	T.M.D.S clock+
0		=	T.M.D.S clock–

24 – ENGLISH