Panasonic DW10000U, PT-D10000U manual Using a colorimeter, Matching, Data

Option1 settings (continued)

■ If “3COLORS” or “7COLORS”
			Adjusting the color matching
was selected in step 2.			using a colorimeter
3. Press ENTER.
			The “R (Red)”, “G (Green)”, “B (Blue)”, “Cy (Cyan)”,
• The “COLOR MATCHING: 3COLORS” or
	“COLOR MATCHING: 7COLORS” screen will		“Mg (Magenta)”, “Ye (Yellow)” and “Wh (White)”
	be displayed.		colors can be changed to the desired hues using
			a colorimeter which is capable of measuring the
			chromaticity coordinates and luminance.
	COLOR MATCHING:3COLORS
	R		■ Inputting the current luminance
	B
	G
			and chromaticity coordinates
	AUTO TESTPATTERN	ON
	MENU SELECT		1. Press ▲▼ to select “COLOR
	ENTER SUB MENU
			MATCHING”.
4. Press ▲▼ to select “R”, “G” and

“B”.

3COLORS:R

R		2048
G		0
B		0
	MENU SELECT
	ADJUST

5.Press ENTER.

6.Press ◄► to adjust the values.

• These values can be adjusted from 0 to 2048.

Note

•The effects of correcting the adjustment color: When tuning the correction color that is the same as the adjustment color: the brightness of the adjustment color changes.

When tuning the correction color RED: RED is added to or reduced from the adjustment color. When tuning the correction color GREEN: GREEN is added to or reduced from the adjustment color. When tuning the correction color BLUE: BLUE is added to or reduced from the adjustment color.

•This adjustment should be carried out by a person who is familiar with the projector or by a service person because a high level of skill is required to make successful adjustment.

•Pressing DEFAULT will restore the factory defaults for all items.

•When any setting other than “OFF” has been selected for color matching, the “COLOR TEMP.” setting is fixed at “USER1”.

OPTION1

COLOR MATCHING	OFF
LARGE SCREEN CORRECTION	OFF
AUTO SIGNAL	OFF
AUTO SETUP
BACK COLOR	BLUE
DVI EDID	EDID2(PC)
AUX DVI EDID	EDID2(PC)
P IN P	OFF
FUNC1	P IN P
OSD POSITION	2
OSD MEMORY	ON

MENU SELECT

CHANGE

2.Press ◄► to select “MEASURE”.

3.Press ENTER.

•The “MEASURE MODE” screen will be displayed.

MEASURE MODE

MODE	709MODE
MEASURED DATA
TARGET DATA
AUTO TESTPATTERN	ON
MENU SELECT
ENTER SUB MENU

4.Press ▲▼ to select “MEASURED

DATA”.

5.Press ENTER.

• The “MEASURED DATA” screen will be displayed.

MEASURED DATA		1/2
Bk	Y	2
	x	0.350
	y	0.360
R	Y	300
	x	0.670
	y	0.330
G	Y	2500
	x	0.350
	y	.0630
B	Y	200
	x	0.150
	y	0.050
MENU SELECT
ADJUST

68 – ENGLISH