Panasonic PT-D10000U Powering up the projector, Making adjustment and selection, Press Power on

) %

# $ *

( -,+-0	%	-
	)

(

&, /+

.

-

Powering up the projector

#Connect the supplied power cable. (120 V AC, 50 Hz/60 Hz)

$ Press the “ ” marked side of the MAIN POWER switch to turn on the power.

•The power indicator lamp on the projector will flash in red. After a short period, the indicator will illuminate and the projector will enter standby mode.

%Press POWER ON “ ”.

•The power indicator lamp illuminates in green and soon the image is projected on the screen.

Note

•If the projector is powered up at about 0 °C, a warm-up period of approximately 5 minutes may be necessary to start projection. The temperature monitor (TEMP) lamp lights up during the warm-up period. When the warm-up is completed, the temperature monitor (TEMP) lamp turns off and the image is projected on the screen.

•If the temperature of the operating environment is low and warm-up takes more than 5 minutes, the projector will judge that a problem has occurred and the power will be turned off automatically. If this happens, increase the temperature around the projector so that it is 0 °C or higher, and then turn on the MAIN POWER switch and the POWER ON “ ” switch once more.

Making adjustment and selection

&Roughly adjust the focus of the lens. (p. 37)

( Select and set the projection scheme. (p. 76)

) Select the input signal by pressing the input selector button to toggle through RGB1, RGB2, DVI-D, VIDEO, S-VIDEO and AUX. (p. 43)

•The AUX button is disabled when an optional input module is not connected.

*Adjust the tilt of the main unit in front and rear or right and left. (p. 20)

+Adjust the shift. (p. 37)

-Press AUTO SETUP if the input signal is RGB signal. (p. 44)

. Fit the image size to the screen size. (p. 37)

/Adjust the focus. (p. 37)

0Display the zoom adjustment menu again and adjust the zoom to fit the image size to the screen size. (p. 37)

Basic Operation

ENGLISH – 35