Panasonic PT-D10000U, DW10000U manual Lamp relay, RS-232C setting

Lamp relay

If using the projector for a continuous period of 24 hours or more, this setting can be used to automatically switch the lamps that are turned on in order to reduce the lamp deterioration that can occur as a result of continuous use.

1.Press ▲▼ to select “LAMP RELAY”.

OPTION2

PROJECTOR ID	2
INSTALLATION	FRONT-F
ALTITUDE	LOW
DIRECTION	H
LAMP SELECT	QUAD
LAMP RELAY	OFF
RS-232C
SYSTEM INFORMATION
AIR FILTER CLEANING
DATE AND TIME
STARTUP LOGO	LOGO1
PASSWORD

MENU SELECT

CHANGE

2.Press ◄► to switch “LAMP RELAY”.

•The time interval for lamps to be switched will change as shown in the diagram below each time ◄► is pressed.

OFF 00:00

23:00 01:00

Note

•When “SINGLE”, “DUAL” or “TRIPLE” is selected as the “LAMP SELECT” setting, the lamps will switch in accordance with the setting time. If “QUAD” is selected, three lamps will illuminate for 8 hours after the specified time.

•The setting time will be the local time. (p. 81)

RS-232C setting

This sets communication parameters for the projector.

1. Press ▲▼ to select “RS-232C”.

OPTION2

PROJECTOR ID	2
INSTALLATION	FRONT-F
ALTITUDE	LOW
DIRECTION	H
LAMP SELECT	QUAD
LAMP RELAY	OFF
RS-232C
SYSTEM INFORMATION
AIR FILTER CLEANING
DATE AND TIME
STARTUP LOGO	LOGO1
PASSWORD

MENU SELECT

ENTER SUB MENU

2.Press ENTER.

• The “RS-232C” screen will be displayed.

RS-232C

SERIAL IN	RS-232C
(IN) BAUDRATE	38400
(IN) PARITY	EVEN
(OUT) BAUDRATE	38400
(OUT) PARITY	EVEN
VPS SYSTEM	MASTER

GROUPA

MASTER

MENU SELECT

CHANGE

3.	Press ▲▼ to select “SERIAL
	IN”.
4.	Press ◄► to switch “SERIAL
	IN”.
	• The setting will change as follows each time
	◄► is pressed.
	RS-232C	RS-422
5.	Press ▲▼ to select
	communication conditions.
6.	Press ◄► to confirm the setting.
7.	Press MENU three times.
	• The on-screen indications disappear, and the
	system returns to the normal screen.

Special Features

ENGLISH – 79