Panasonic DW10000U, PT-D10000U Using the Remote 2 terminal, Example of a control panel layout

Using the Remote 2 terminal

Using the REMOTE 2 terminal provided on the connection terminals of the main unit, it is possible to operate the projector from a control panel etc. furnished in a distant location where infrared remote control signal cannot be received.

Example of a control panel layout

Remote terminal External control

Remote terminal/External control

STANDBY ON

LAMP

RGB1VIDEO

RGB2S-VIDEO

DVI-D

Projector set up in a meeting room Control panel located in a different room

Pin assignments and control

Be sure to short-circuit Pins # and - when controlling.

D-Sub 9-pin (female)

external appearance

	Names of terminals	Open (H)	Short (L)
#	GND		GND
$	POWER	OFF	ON
%	RGB1	Other	RGB1
&	RGB2	Other	RGB2
(	VIDEO	Other	VIDEO
)	S-VIDEO	Other	S-VIDEO
*	DVI-D	Other	DVI-D
+	SHUTTER	OFF	ON
-	RST / SET	Controlled by	Controlled by
		remote control	external contact

Note

•When pin # and pin - are short-circuited, the following buttons on the projector's control panel and on the remote control cannot be used.

POWER button, SHUTTER button

In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either.

•When pin # and pin - are short-circuited and then any one of pins % to * is short-circuited to pin #, the following buttons on the projector's control panel and on the remote control cannot be used.

POWER button, input selection buttons (RGB1, RGB2, DVI-D, AUX, VIDEO, S-VIDEO), SHUTTER button

In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either.

106 – ENGLISH