Panasonic DW10000U, PT-D10000U manual Always disconnect all cables before moving the projector

Precautions with regard to safety (continued)

CAUTION

■Do not set up the projector in humid or dusty places or in places where the projector may come into contact with smoke or steam.

•Using the projector under such conditions may result in fire or electric shocks.

■When disconnecting the power cord, hold the plug, not the cord.

•If the power cord itself is pulled, the cord will become damaged, and fire, short-circuits or serious electric shocks may result.

■Always disconnect all cables before moving the projector.

•Moving the projector with cables still attached can damage the cables, which could cause fire or electric shocks to occur.

■Do not place any heavy objects on top of the projector.

•Failure to observe this may cause the projector to become unbalanced and fall, which could result in damage or injury.

■Do not short-circuit, heat or disassemble the battery or place it into water or fire.

•Failure to observe this may cause the battery to overheat, leak, explode or catch fire, and burns or other injury may result.

■When inserting the battery, make sure the polarities (+ and -) are correct.

•If the battery is inserted incorrectly, it may explode or leak, and fire, injury or contamination of the battery compartment and surrounding area may result.

■Use only the specified battery.

•If an incorrect battery is used, it may explode or leak, and fire, injury or contamination of the battery compartment and surrounding area may result close to this port, otherwise burns or damage could result.

■Do not look into the lens while the projector is being used.

•Strong light is emitted from the projector’s lens. If you look directly into this light, it can hurt and damage your eyes.

■Do not place your skin into the light beam while the projector is being used.

•Strong light is emitted from the projector’s lens. If you place directly into this light, it can hurt or damage your skin.

■Do not bring your hands or other objects close to the air outlet port.

•Heated air comes out of the air outlet port. Do not bring your hands or face, or objects which cannot withstand heat.

■Do not use the old lamp unit.

•The lamp section may break.

■Replacement of the lamp unit should only be carried out after it has completely cooled off, otherwise burns may result.

8 – ENGLISH