Henny Penny EEG-141, EEG-142, EEG-144, EEG-143 warranty Error Codes, Display Cause Correction

		Model EEG-141, 142, 143, 144
7-2. ERROR CODES		In the event of a control system failure, the digital display shows an
		error message. The message codes are shown in the DISPLAY
		column below. A constant tone is heard when an error code is
		displayed, and to silence this tone, press any button.
DISPLAY	CAUSE	CORRECTION
“E-4”	• Control board	• Turn switch to OFF position, then turn switch back to ON;
	overheating	if display shows “E-4”, the control board is getting too hot;
		check the louvers on each side of the unit for obstructions
“E-5”	• Oil overheating	• Turn switch to OFF position, then turn switch back to ON;
		if display shows “E-5”, the heating circuits and temperature
		probe should be checked
“E-6A”	• Temperature	• Turn switch to OFF position, then turn switch back to ON;
	probe open	if display shows “E-6A”, the temperature probe should be
		checked
“E-6B”	• Temperature	• Turn switch to OFF position, then turn switch back to ON;
	probe shorted	if display shows “E-6B”, the temperature probe should be
		checked
“E-10”	•Highlimit	• Press the red reset button under the right side of the controls;
		if high limit does not reset, high limit must be replaced

“E-15”	Drain switch	Make sure drain knob is completely pushed-in; if E-15 persists,
		have drain switch checked
“E-18-A”	• Left level sensor open	• Turn switch to OFF position, then turn switch back to ON; if
“E-18-B”	• Right level sensor open	display still indicates a failed sensor, have the connectors
“E-18-C”	• Both level sensors open	checked at the control board; have sensor checked & replace if
		necessory
809		7-3