Henny Penny EEG-141, EEG-142, EEG-144, EEG-143 warranty Basic Operation Idle Mode

3-5. BASIC OPERATION

3-6. IDLE MODE

809

Model EEG-141, 142, 143, 144

1.Once out of the Melt Cycle, LOW TEMP flashes until the set- point temperature has been reached. Once the set-point temperature has been reached, the product name now shows in the display, ex: FRY, and product now can be placed in the oil.

2. Press a timer button or .

3.Display shows the name of the product cooking(ex: “FRY”) and the timer counting down.

4.When cook cycle is complete, and alarm sounds and display shows “DONE”.

5.Press the timer button under “DONE” to stop the alarm, and lift basket from vat.

6.If a Quality Timer (hold timer) has been programmed, the hold time starts automatically when the user presses the timer button to end the cook cycle. While the quality timer counts down, the display shows the three-digit product abbreviation followed by “Qn”, where “n” is the number of minutes remaining.

ex: “FRY” / “Q5” / “FRY” / “Q5” / “FRY” / “Q4”, etc.

At the end of the timer countdown, the control beeps and the display shows “QUAL” followed by the three-digit product name: “QUAL” / “FRY” / “QUAL”/ “FRY”. Press the timer button to cancel the timer.

To stop a cook cycle at any time, press and hold the timer

button or .

Once programmed, the Idle Mode help saves on oil and utility costs by lowering the set-point of the oil when the vat is not being used. To activate the Idle Mode, press the button, or can be programmed to activate automatically after “X” minutes of inactivity on the vat.

The oil is maintained at a lower temperature until the button is pressed, and then the oil is heated to cooking temperature. See Special Program Modes, SP-12, SP-13 & SP-14.

3-8