Henny Penny EEG-141, EEG-142, EEG-144, EEG-143 warranty Limited Warranty for Henny Penny Equipment

Page 5

LIMITED WARRANTY FOR HENNY PENNY EQUIPMENT

Subject to the following conditions, Henny Penny Corporation makes the following limited warranties to the original purchaser only for Henny Penny appliances and replacement parts:

NEW EQUIPMENT: Any part of a new appliance, except baskets, lamps, and fuses, which proves to be defective in material or workmanship within two (2) years from date of original installation, will be repaired or replaced without charge F.O.B. factory, Eaton, Ohio, or F.O.B. authorized distributor. Baskets will be repaired or replaced for ninety (90) days from date of original installation. Lamps and fuses are not covered under this Limited Warranty. To validate this warranty, the registration card for the appliance must be mailed to Henny Penny within ten (10) days after installation.

FILTER SYSTEM: Failure of any parts within a fryer filter system caused by the use of the non-OEM filters or other unapproved filters is not covered under this Limited Warranty.

REPLACEMENT PARTS: Any appliance replacement part, except lamps and fuses, which proves to be defective in material or workmanship within ninety (90) days from date of original installation will be repaired or replaced without charge F.O.B. factory, Eaton, Ohio, or F.O.B. authorized distributor.

The warranty for new equipment covers the repair or replacement of the defective part and includes labor charges and maximum mileage charges of 200 miles round trip for a period of one (1) year from the date of original installation.

The warranty for replacement parts covers only the repair or replacement of the defective part and does not include any labor charges for the removal and installation of any parts, travel, or other expenses incidental to the repair or replacement of a part.

EXTENDED FRYPOT WARRANTY: Henny Penny will replace any frypot that fails due to manufacturing or workmanship issues for a period of up to seven (7) years from date of manufacture. This warranty shall not cover any frypot that fails due to any misuse or abuse, such as heating of the frypot without shortening.

0 TO 3 YEARS: During this time, any frypot that fails due to manufacturing or workmanship issues will be replaced at no charge for parts, labor, or freight. Henny Penny will either install a new frypot at no cost or provide a new or reconditioned replacement fryer at no cost.

3 TO 7 YEARS: During this time, any frypot that fails due to manufacturing or workmanship issues will be replaced at no charge for the frypot only. Any freight charges and labor costs to install the new frypot as well as the cost of any other parts replaced, such as insulation, thermal sensors, high limits, fittings, and hardware, will be the responsibility of the owner.

Any claim must be presented to either Henny Penny or the distributor from whom the appliance was purchased. No allowance will be granted for repairs made by anyone else without Henny Penny’s written consent. If damage occurs during shipping, notify the sender at once so that a claim may be filed.

THEABOVE LIMITED WARRANTYSETS FORTH THE SOLE REMEDYAGAINST HENNYPENNYFORANYBREACH OF WARRANTY OR OTHER TERM. BUYERAGREES THAT NO OTHER REMEDY (INCLUDING CLAIMS FORANY INCI- DENTALOR CONSEQUENTIALDAMAGES) SHALLBEAVAILABLE.

The above limited warranty does not apply (a) to damage resulting from accident, alteration, misuse, or abuse; (b) if the equipment’s serial number is removed or defaced; or (c) for lamps and fuses. THE ABOVE LIMITED WARRANTY IS EX-

PRESSLY IN LIEU OFALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING MERCHANTABILITYAND FIT- NESS,ANDALL OTHER WARRANTIESARE EXCLUDED. HENNYPENNY NEITHERASSUMES NORAUTHORIZESANY PERSON TOASSUME FOR ITANYOTHER OBLIGATION OR LIABILITY.

Revised 01/01/07

Image 5
Contents OPERATOR’S Manual Page FM05-057-C Revised Technical Data for CE Marked Products Limited Warranty for Henny Penny Equipment Table of Contents Section Table of Contents Page Proper Care FeaturesIntroduction Assistance SafetySafety Page Unpacking InstallationSelecting the Fryer Location Leveling the Fryer GAS Supply GAS Supply GAS Supply Model EEG-141, 142, 143 Motor Bearings Lightingand Shutdown of the Burners Electrical RequirementsDimensions Page Refer to explanations on the next pages Operation Operating ComponentsFunction Operating ComponentsDescription Description Function JIB VAT Type Full or Split SET-UP ModeFill POT from Bulk Filling or Adding OILMorning START-UP Procedures Basic Operation Idle Mode Selectinga Product Withadifferent Setpoint Replacing the JIB OIL Guardian Auto Top-OffModel EEG-141 OIL Removing/Cleaning ReservoirReservoir Filling Oil ReservoirSmartfilter Express Smartfilter Express Filter ErrorCheck Filter Pan a new filter pad should be used on Daily FilteringDaily Filtering Discarding OIL from VAT Using Optional OIL Discard Shuttle Express FILTER? Changing the Filter PAD Changing the Filter PAD Removing and Cleaning Basket Rest CLEAN-OUT CLEAN-OUT ModeCLEAN-OUT Mode Rinse Complete YES no CHECK/REPLACE Filter Drain PAN O-RINGS Recovery Information for each Vat Actual Oil TemperatureInfo Button Stats Filter Button StatsProcedureFrequency Preventive Maintenance ScheduleClean Blower & Vents Page Information Mode Details Information ModeFunction Display EX DetailsTUE NEW OIL Reset usage data Assign Button Product Program Mode Modifying Product SettingsChange Product Names To Change Times and Temperatures Modifying Product SettingsAlarms 1 Quality Timer hold timeMixFilterdAfterFil TrackingX Number of Loads Filter Control Level 2 Programming Special Program ModeAudio Volume SP-4 Special Program ModeDegrees Fahrenheit or Celsius SP-1 Language SP-2Liquid or Solid Cooking Oil Used SP-6 Idle Mode Enabled SP-7Audio Tone SP-5 Mixed Filter Tracking Mode SP-8If Global is selected, press button GlobalClean-Out Temperature SP-12 Clean-Out Time SP-11Cooking Indicator SP-15 Polish Duration SP-9Engery Save Mode SP-18 2nd Volume SP-172nd Language SP-16 Fryer Type SP-19Bulk Oil Supply SP-22 Autolift Enabled SP-21Bulk Oil Disposal SP-23 Serial Number Log SP-24Dispose Requires Code ? SP-27 Usage Code Change SP-26Longer Fill Time SP-28 Let User Exit Fill SP-29Model EEG-141, 142, 143 Problem Cause Correction Troubleshooting Trouble Shooting GuideRemove the right side panel Display Cause Correction Error CodesClosed Error Codes Display Cause CorrectionPage Henny Penny Corporation Box Eaton,OH Toll free in USA