Henny Penny OFE- 291 manual Clock SET

Page 6

Model OFE- 291

3-4. CLOCK SET

Upon initial start-up, or PC board replacement, if “CLOCK SET” automatically appears in the display, start with step 4.

1.Press and hold for 5 seconds until “LEVEL 2” shows in display.

2.Press and “CLOCK SET”, “ENTER CODE” shows in display.

3.Press .

4.“CS-1, SET, MONTH”, and the month flashes in the display.

5.Press the to change the month.

6.Press and “CS-2, SET, DATE” shows in the display, with the date flashing.

7.Press to change the date.

8.Press and “CS-3, SET, YEAR” shows in the display, along with the year flashing.

9.Press to change the year.

10.Press and “CS-4, SET, HOUR” shows in the display, with the hour and “AM” or “PM” flashing.

11.Press to change the hour and AM/PM setting.

12.Pressand “CS-5, SET, MINUTE” shows in the display, with the minutes flashing.

13.Press to change the minutes.

3-6

403

Image 6

Contents Operation Operating Components LID Operation Switches IndicatorsDescription Function Switches and Indicators Description Function Model OFE 403 Clock SET Clock SET Filling or Adding Shortening Product Racking Recommendations Be Certain the Shortening is Never Above the Upper Frypot LevelindicatorBasic Operation LINE. Failure to Follow These InstrucAllow fryer to heat until Illuminates Unlatch and raise the lid cautiously Which could Result in Serious Burns Care ShorteningShortening Overflowingthe Frypot Personal INJURY, FIRE, AND/OR PropertyFiltering Instructions Filtering Instructions Only Connectand Disconnect the Filter Rinse Hose When the Main Power SwitchFiltering Instructions Is in the OFF POSITION. ALSO, USE a DRYEnvelope Filter Pump Motor PROTECTOR-MANUAL Reset Cleaningthe Frypot If hot shortening is present in the frypot, it must be Drained by slowly pulling the drain handle out towards youCleaning the Frypot Does not boil over causing damage to controlsMaintenance Procedure FrequencyCleaning Nylatrons Monthly PreventiveProgramming Change Product NamesProgramming Filter Cycle Mode Optional ProgrammingGo to Idle after Done? Global Erase a Prod Preset a Prod Erase ALL Special Program ModeSystem Initialization SP-3 Language SP-2 ModeAudio Volume SP-4 Audio Tone SP-5Idle Mode SP-7 Type of shortening to be melted Liquid or Solid SP-6Mixed Press SP-8C shows in the display, if YES Special Program Schedule To filter the shortening. Press To changeProduct Buttons Sp-9 Mode Clean-Out Temperature Sp-10Clean-Out Temperature Sp-11 Mode Program Code Change SP-15 Usage Code Change SP-16If satisfied with code, press Mode Shows in display If not satisfied with code, pressData LOGGING, Heat CONTROL, Tech MODE, and Stat Mode Code ChangePress to continue to Last Load Information Mode Last Load Function DisplayexInformation Mode Function Display EXOutp H* P OIL TMP CPU TMPAnalog 1