Model OFE- 291
| 4. Allow fryer to heat until | illuminates. |
(Continued) |
|
|
Bypass the melt cycle, if desired, by pressing a product button and holding it for five seconds. The display shows
“EXIT MELT? 1=YES 2=NO”. Press 
to exit melt.
Do not bypass the Melt Cycle unless enough shortening has melted to completely cover all of the heating elemets. If the Melt Cycle is bypassed before all heating elements are covered, excessive smoking of shortening, or a fire could result.
The heat cycles on and off about 10 degrees before the setpoint temperature, to help prevent overshooting the setpoint temperature. (proportional control)
Once out of the Melt Cycle, 
temperature is reached. Then product shows in the display.
flashes until 5° before setpoint illuminates and the selected
5.Slide racks of breaded product into carrier on the lid, starting with the bottom rack, to prevent damaged product.
Before loading product onto the racks, lower the racks into the hot shortening to prevent the product sticking to the racks.
6.Lower and latch the lid, and press 
.
A different product can be selected during the first minute of
cooking, in case the wrong product button was pressed. To check the shortening temperature press or to stop a
Cook Cycle, press
.
7.At the end of the cycle, an alarm sounds, while the display
shows “DONE”. Then press 
.
403 |