Garland Salamander Broiler service manual Wall Or Counter Mounted Salamanders Model UIR36C

INSTALLATION Continued

2.Install the left and right support brackets (part # 4523226 and 4523227) using the 2 screws removed in step 1 (detail I) and one additional screw on both sides of the range, and center support bracket (part # 4523282) with the four screws removed in step 1 (detail II)..

INSERTED

SCREWS

DETAIL I

ALL 60" MODELS

4 INSERTED SCREWS

DETAIL II

FOR 60" RANGES

WITH STANDARD OVEN

4 INSERTED SCREWS

DETAIL II

FOR 60" RANGES

WITH CONVECTION OVEN

3.Slide the salamander down into the support brackets installed in step 2, see figure 3..

4.Once the salamander is in place, fasten it to the unit on both sides of the range with the provided #14B x 5/8 hex washer head tapping screws (detail I) and the center to the support bracket using 4 of the provided screws (detail II)..

PROVIDED #14B x 5/8 HEX WASHER HEAD TAPPING SCREWS

DETAIL I

ALL 60" RANGES

4 PROVIDED

SCREWS

DETAIL II

ALL 60" RANGES

Wall Or Counter Mounted Salamanders

Model UIR36C

1.Clearance from combustible construction must be six inches (6”, 152mm) minimum at the rear and six inches (6”, 152mm) minimum at both sides..

The appliance shall be located with respect to building construction and other equipment so as to permit access to the appliance.. Such access and clearance may be necessary for service and cleaning..

2.Counter models are furnished with 4” (102mm) legs.. Level the unit with a carpenter’s level and make minor adjustments with the threaded leg feet.. Ensure that the counter top can support the weight of the appliance prior to installation and is comprised of non-combustible material..

Part # 4523974 (11/07) Page 13