DCS RGSC-305SS, RGSC-305BK, RGSC-305WT manual Igniters, Control Knobs Cooktop and Oven

Page 26

Locating Pin Hole Inside

Venturi

Electrode

Locating Pin

Burner

Base

Locating Notch

Simmer Ring

Hex Nut

Main

Burner Port Ring

Brass Ring Locating Pin

Cap

CARE AND MAINTENANCE

BURNERS

For proper lighting and performance keep the burners clean. It is necessary to clean the burners if they do not light even though the igniter clicks, if there has been a severe boil over, or when the flame does not burn blue.

Be certain all burner knobs are in the OFF position before attempting to clean the burners.The burners have been designed for ease in cleaning. When the grates and burners are cool, remove the grate. The Burner Cap and the Brass Port Ring can easily be lifted off. Wash these parts in hot soapy water, rinse and dry thoroughly. The Burner Caps are porcelain enamel, follow the directions on the previous page that were given for the burner

grates. A bristle brush can be used to clean out the toothed burner

ports, if necessary. Disassembly of the Simmer Ring is not

recommended, however, it may become necessary to do so if the ports remain clogged after normal

cleaning. If it is necessary to disassemble the Simmer Ring from

the Base, remove the Hex Nut at

the top of the Simmer Ring. Clean the Simmer Ring with hot soapy

water using a soft wire or plastic bristle brush then dry thoroughly.

Re-assemble the parts using the Hex Nut.

After cleaning, it is important to make sure the Locating Pin on the

bottom side of the Simmer Ring is properly aligned with the corresponding hole in the Base

and that the Locating Pin (see insert) in the bottom side of the Brass Port Ring is properly aligned

with the Locating Notch on the top side of the Simmer Ring. Incorrect alignment will produce a potentially dangerous flame and poor burner performance. See the illustration.

IGNITERS

Wipe with a water-dampened cotton swab. Be careful not to damage the igniter. (See illustration)

CONTROL KNOBS – COOKTOP AND OVEN

These are plastic and can be cleaned in hot, soapy water. To remove the knobs from the control panel, grasp the knob and pull straight forward. Wash, do not soak. Rinse and dry thoroughly. It is important to replace these knobs on the correct gas valve on the control panel.

IGNITER (keep clean)

25

Image 26

Contents Five Burner Self Cleaning GAS Range Message to OUR Customers Please Retain this Manual for Future ReferenceTable of Contents Table of Contentscustomers Safety Practices to Avoid Personal Injury Safety Practices to Avoid Personal Injury Recommendations on HOOK-UP to GAS Supply Parts List Parts IdentificationOven Interior Before Using Your Appliance CooktopSimmering Cooktop USEBurners Burner Efficiency and Flame Characteristics Electronic IgnitersBurner Grates Flame HeightSealed Top Burners w/ Grates removed Cooking Utensils Control KnobsGeneral Using Convection Bake and Regular BakeOven USE Converting Recipes to Convection Bake Convection BakeFoods Suitable for Convection Bake Selecting Utensils for Convection BakeFoods Suitable for Bake Regular BakeRacks Positions To Set the Oven for Convection Broil and Broil Using Convection Broil and BroilTo Get the Best Results BakingRegular Broil Rack PositionConvection Broil Using a Meat Thermometer to Broil and Convection Broil To Use the Oven for Slow Cooking or Low Temperatures High Altitude BakingSuggested Temperatures to Keep Food HOT Internal Cooking TemperaturesBefore SELF-CLEANING the Oven Oven SELF-CLEANINGOven Door Lock During SELF-CLEAN Setting the Oven for SELF-CLEAN AT the END of the Clean CycleCooktop Care and MaintenanceBe careful cleaning any part of this appliance while hot Igniters Control Knobs Cooktop and OvenBackguard if Installed Oven and Door InteriorOven Racks and Rollers Oven Light Bulb ReplacementPower Failure FRAME, SIDES, Door EXTERIOR, Heat DeflectorIf the Cooktop Burners do not Light Before YOU Call for ServiceService Information Service HOW to Obtain ServiceDCS will PAY for WarrantyLength of Warranty DCS will not PAY forWarranty Manuel dutilisation et dentretien Ou par courrier Notre ClientèleVeuillez Conserver CE Manuel À Titre DE Référence Utilisation DE LA Table DE Cuisson Table DES MatièresConsignes DE Sécurité Pour Éviter LES Blessures Utilisation DU FourEntretien ET Maintenance Autonettoyage DU FourConsignes DE Sécurité Pour Éviter LES Blessures Consignes DE Sécurité Pour Éviter LES Blessures Consignes DE Sécurité Pour Éviter LES Blessures Recommandations EN Matière DE Branchement DU GAZ Identification DES Pièces Liste DES PiècesIntérieur DU Four Avant Dutiliser Votre Appareil Table DE CuissonCuisson À Petit FEU Utilisation DE LA Table DE CuissonBrûleurs Allumeurs Électroniques Efficacité DES Brûleurs ET Caractéristiques DE LA FlammeHauteur correcte de la flamme Hauteur DE LA FlammeGrilles DES Brûleurs Boutons DE Réglage Utilisation DU FourUstensiles DE Cuisson GénéralitésCuisson Par Convection Utilisation DE Cuisson PAR Convection ET DE Cuisson AU FourPréchauffage Aliments appropriés pour une cuisson par convectionLa position de grille Conversion des recettes pour la cuisson par convectionSélection des ustensiles pour la cuisson par convection Aliments appropriés pour la cuisson au four Cuisson Au FourPour Obtenir Les Meilleurs Résultats Cuisson Au FourRéglage Du Four Pour Grillage Normal Et À Convection Cuisson par convectionGrillage Normal La Position Des GrillesGrillage Par Convection Pour Obtenir Les Meilleurs Résultats Remarque Rôtir à Haute AltitudeTempératures Suggérées Pour Garder LES Aliments Chauds AlimentsAvant Lautonettoyage DU Four Autonettoyage DU FourVerrouillage DE LA Porte DU Four Durant Lautonettoyage Réglage DU Four Pour Lautonettoyage LA FIN DU Cycle DE NettoyageEntretien ET Maintenance Table DE CuissonAllumeurs Intérieur DU Four ET DE LA Porte Dosseret SI InstalléBoutons DE Réglage Table DE Cuisson ET Four CADRE, CÔTÉS, Extérieur DE PORTE, Déflecteur Remplacement DE Lampoule DE Lampe DU FourGrilles ET Rails DU Four Joint DE PorteSI LES Brûleurs DE LA Table DE Cuisson NE Sallument PAS Avant Dappeler LE Service TechniquePour Lobtention DE Service Pour Lobtention DU Service DE Garantie DCS Couvre LES Frais Suivants GarantieDurée DE LA Garantie DCS NE Couvre PAS LES Frais SuivantsGarantie Part No Rev E Litho in USA 08/2004