Toshiba VF-S11 manual Ry Rc

				E6581160
Terminal	Input/output	Function	Electrical	Inverter internal circuits
symbol			specifications

2

RY RC

Output

Multifunction programmable relay contact output.

Standard default settings detect and output low-speed signal output frequencies.

Multifunction output terminals to which two different functions can be assigned.

250Vac-1A (cosφ=1)

:at resistance load 30Vdc-0.5A 250Vac-0.5A (cosφ=0.4)

+24V

RY RY RC

QSINK (Negative) logic/SOURCE (Positive) logic (When the

inverter's internal power supply is used)

Current flowing out turns control input terminals on. These are called sink logic terminals. (Type: -AN/-WN). The general used method in Europe is source logic in which current flowing into the input terminal turns it on (Typ: -WP).

Sink logic is sometimes referred to as negative logic, and source logic is referred to as positive logic. Each logic is supplied with electricity from either the inverter's internal power supply or an external power supply, and its connections vary depending on the power supply used.

＜Examples of connections when the inverter's internal power supply is used＞

Slide switch SW1:SINK	Slide switch SW1:SOURCE
Sink (Negative) logic		Source (Positive) logic

	24VDC	Input
Output	F
Common	CC
	24VD	Output
Common	P24
Input	OUT
	NO
	CC

	24VDC
Common	P24	Input
Output	F
	24VDC	Output
	P24
	OUT
Input	NO
Common CC

Programmable	Inverter	Programmable	Inverter
controller		controller

16