Toshiba VF-S11 manual Table of output terminal functions, AD3

E6581160

QTable of input terminal functions 3

Function	Code	Function	Action
No.
54	STN	Coast stop (gate off)	ON: Coast stop (gate off)
55	RESN	Inversion of RES	ON: Acceptance of reset command
			OFF→ ON: Trip reset
56	F+ST	Combination of forward run and standby	ON: Simultaneous input from F and ST
57	R+ST	Combination of reverse run and standby	ON: Simultaneous input from R and ST
58	AD3	Acceleration/deceleration 3 selection	ON: Acceleration/deceleration 3
			OFF: Acceleration/deceleration 1 or 2
59	F+AD3	Combination of forward run and	ON: Simultaneous input from F and AD3
		acceleration/deceleration 3
60	R+AD3	Combination of reverse run and	ON: Simultaneous input from R and AD3
		acceleration/deceleration 3
61	OCS2	Forced switching of stall prevention level 2	ON: Enabled at the value of H
			OFF: Enabled at the value of H
62	HDRY	Holding of RY-RC terminal output	ON: Once turned on, RY-RC are held on.
			OFF: The status of RY-RC changes in real time
			according to conditions.
63	HDOUT	Holding of OUT-NO terminal output	ON: Once turned on, OUT-NO are held on.
			OFF: The status of OUT-NO changes in real time
			according to conditions.
64	PRUN	Cancellation (clearing) of operation command from	0: Operation command canceled (cleared)
		panel	1: Operation command retained
65	ICLR	PID control integral value clear	ON: PID control integral value always zero
			OFF: PID control permitted

Q Table of output terminal functions 1				7
Function	Code	Function	Action
No.
0	LL	Frequency lower limit	ON: The output frequency is above the NN set
			value.
			OFF: The output frequency is equal to or less than
			the NN set value.
1	LLN	Inversion of frequency lower limit	Inversion of LL setting
2	UL	Frequency upper limit	ON: Output frequency is equal to or higher than
			WN value.
			OFF: Output frequency is lower than WN value.
3	ULN	Inversion of frequency upper limit	Inversion of UL setting
4	LOW	Low-speed detection signal	ON: Output frequency is equal to or higher than
			H value.
			OFF: Output frequency is lower than H
			value.
5	LOWN	Inversion of low-speed detection signal	Inversion of LOW setting
6	RCH	Designated frequency attainment signal	ON: The output frequency is equal to or less than
		(completion of acceleration/deceleration)	the specified frequency ± frequency set with
			H.
			OFF: The output frequency is above the specified
			frequency ± frequency set with H.
7	RCHN	Inversion of designated frequency attainment	Inversion of RCH setting
		signal (inversion of completion of
		acceleration/deceleration)
8	RCHF	Set frequency attainment signal	ON: The output frequency is equal to or less than
			the frequency set with H ± H.
			OFF: The output frequency is above the frequency
			set with H ± H.
9	RCHFN	Inversion of set frequency attainment signal	Inversion of RCHF setting
10	FL	Failure signal (trip output)	ON: When inverter is tripped
			OFF: When inverter is not tripped
11	FLN	Inversion of failure signal (inversion of trip output)	Inversion of FL setting

67