Black & Decker CM1936ZF2 Preparation, Unpacking Figures A, B, Handle Assemblyfigure C

Page 5

PREPARATION

 

 

PLEASE REFER TO DIAGRAMS (A, B, C...) AND ITEM NUMBERS (1, 2, 3...) AS NOTED THROUGHOUT MANUAL. FOR EXAMPLE,

A-1 REFERS TO ITEM 1 IN FIGURE A.

 

UNPACKING - (FIGURES A, B)

 

CAUTION: Pinch point. To avoid being pinched, keep fingers away

from area between handle and plates.

 

STEP 1:

 

 

Carefully cut down the sides of the box on the opposite end of the handle

and fold the flap down as shown.

WARNING:

Sharp blade. Keep

body parts away from blade.

 

 

WithSTEPthe2: carton end cut open, remove the cardboard filler, charger,

B

 

accessory bag and grass bag and push the mower out of the opened

 

 

carton.

 

 

ASSEMBLY

 

 

Tools required for assembly, not supplied:

 

 

Adjustable or 1/2 inch (13mm) wrench.

 

 

HANDLE ASSEMBLY(FIGURE C)

2

 

1. Position the handle so that the handle holes line up with the deck side

1

plate holes. The handle quick adjust knobs C-2will line up with the

 

deck side plate top holes.

 

2. Place handle attachment bolts C-1through the handle holes and

 

 

thread into the deck side plate. Before tightening repeat for other side.

 

 

3. Tighten handle attachment bolts C-1securely using adjustable or 1/2

 

 

inch (13mm) wrench. Ensure that each bolt is tightened until their

 

 

shoulder bottoms out on the plate.

 

 

4. To set desired handle height refer to handle adjustment. Do not push

 

 

or use mower unless handle is properly fastened and secured to

 

 

mower.

2

 

The handle quick adjust knobs C-2 will appear as shown in figure C

 

when they are fully engaged into the plates.

 

CAUTION: Pinch point. To avoid being pinched, keep fingers away from

1

 

area between handle and plates when raising or adjusting.

 

HANDLE ADJUSTMENT (FIGURE D)

 

1. Remove safety key.

 

1

2. Hold handle with one hand, pull out and rotate one handle quick

 

adjust knob D-1on mower handle a quarter-turn to release the pin

 

 

from the metal plate hole. Handle quick adjust knob D-1will remain

 

 

in this retracted position. Repeat for the opposite side knob. Now the

 

 

handle is free to move into another handle height position.

 

 

3. Move the handle to desired height position. Taller users will prefer

 

 

using the top hole position, while shorter users may prefer the bottom

 

 

hole position. While holding handle with one hand, pull out and rotate

 

 

one handle quick adjust knob D-1a quarter-turn to re-engage pin

 

 

into metal plate hole. Repeat for the other knob.

 

 

4. Shake handle slightly to ensure handle pins are fully engaged prior to

 

 

using mower. Do not push or use the mower unless handle is properly

 

 

fastened and secured to mower. The handle quick adjust knobs D-1

 

 

will appear as shown in figure D when the knob pins are fully engaged

1

 

into the plates.

 

CAUTION: Pinch point. To avoid being pinched, keep fingers away from

 

 

area between handle and plates when raising or adjusting.

 

 

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents VEA EL Español EN LA Contraportada Please Read Before Returning this Product for ANY ReasonKEY Information YOU should Know Before crossing walk, roads, patio and gravel drives Read ALL InstructionsPersonal injury, including the following To Reduce Risk of InjuryUSE of Extension Cords With no cracks or deteriorationContain long hair Never wear radio or music headphones while operating mowerUnclog the chute or remove anything from under the deck Keep Hands and feet away from cutting areaHandle Assemblyfigure C AssemblyHandle Adjustment Figure D PreparationGrassbag Frame Clip Assembling the Grass Catcher Figures E1, E2, E3, E4Removing Battery from Mower Figure H BatteryCharger Safety Rules Important Safety InstructionsOperation Safety Shield and Rear Door Figure M Installing Grass Catcher Figure N, OMeets Cpsc Safety Requirements Mower OverloadYour mower is now in Bagging mode Mulching Mode Discharge ModeON-DEMAND Mowing TipsRemoving and Installing Blade Figure R MaintenanceMulching Mowing Tips Wrench R-2 as shown in figure RBlade Sharpening CleaningBlade Balancing LubricationRbrc Seal Battery Recycling Battery Service and InstallationStorage Position OFF-SEASON StorageBattery and mower perform much better if charged fully Problem SolutionBag full. Empty bag more often WarrantiesGuide DʼUTILISATION Lire Toutes CES Directives Conserver CES Mesures Pièce, est endommagé, il faut faire Bon calibre à utiliser, consulter le tableau suivantAssemblage PréparationDéballage Illustrations A, B AvertissementDans les plaques Ensemble DE Poignée Figure CRéglage DE LA Poignée Figure D Pile Réglage DE LA Hauteur DES Roues 38 MM ÀRetrait DE LA Pile DE LA Tondeuse Illustration H Reporter À LA Section SUR LE Rangement Hors SaisonProcédure DE Charge ILLUSTRATIONSI, J FonctionnementConnaître SA Tondeuse CLÉ DE SûretéInterrupteur DE MARCHE/ARRÊT Anse Illustration L Démarrage DE LA TondeuseSurcharge DE LA Tondeuse Écran Protecteur ET Panneau Arrière Illustration M« Sélection DE Mode » Installation DU Collecteur DherbeConseils Pour LE Déchiquetage Mode de déchiquetageConseils Pour Tondre LA Pelouse Entretien Retrait ET Installation DE LA Lame Illustration RAffûtage DE LA Lame Lors DE Laffûtage DE LA LameNettoyage Équilibrage DE LA LamePrévention DE LA Corrosion Transport ET RangementRangement Hors Saison Entretien ET Installation DE LA PileLE Sceau Srprc Recyclage DES Piles Rechargeables 800Problème Solution Remarque ProblèmeLa tondeuse ne ramasse pas lherbe coupée dans le sac Moins. Ne pas couper plus du tiers de la longueur totaleManual DE Instrucciones Pautas DE SEGURIDAD/DEFINICIONES Page Deben usarse piezas de repuesto idénticas DeterioroUSO DE Cables Prolongadores Ensamblaje PreparaciónDesembalaje Figuras A, A1, A2 Descripción DE LAS Funciones CM1936ZF2Ajuste DEL Mango Figura D Ensamblaje DEL Mango Figura CEnsamblado DEL Recolector DE Césped Figuras E1, E2, E3, E4 Ubique el mango de manera que los orificios de éste quedenRetiro DE LA Batería DE LA Podadora BateríaLa empuñadura F-2 y manténgala así Sección DE Almacenamiento Fuera DE TemporadaOperación Sobrecarga DE LA Podadora Para Encender LA PodadoraInstalación DEL Recolector DE Césped DE Seguridad Y Puerta TraseraLA Deje SIN Supervisión Aunque SEA Durante UN Período Breve Operación Según RequerimientoConsejos Para EL Corte DE Césped Consejos Para EL Corte DE Césped Para Formar Mantillo MantenimientoRetiro E Instalación DE LA Hoja Figura R InalámbricaSimetría DE LA Hoja Afilado DE LA HojaLubricación LimpiezaPosición DE Almacenamiento Transporte Y AlmacenamientoAlmacenamiento Fuera DE Temporada Mantenimiento E Instalación DE LA BateríaGarantías Problema Solución Esta Garantia no Aplica Cuando NotaAños DE Garantia Solamente Para Propositos DE Mexico
Top Page Image Contents