Black & Decker CM1936ZF2 instruction manual Operation

Page 8

CHARGING PROCEDURE- FIGURES I, J

1. To charge your mower remove the battery from the mower first.

2. Align the charger plug I-1with the arrow on top and insert the charger plug into the receptacle I-2on the battery pack (blue terminal to blue terminal, white terminal to white terminal). The charger connector can only be plugged into the battery one way.

3. There are two charging rates to choose from when charging the bat- tery. The charger will default to the “normal” or regular charging rate. NORMAL CHARGING RATE - When in this mode, the red light J-1on the charger should come on indicating you have power and the bat- tery is being charged. Check the charger for the red light, if it is not on check the charger connector for proper alignment (step 2). The red light should extinguish and the green light J-1will come on when charging is complete (takes approximately 12 hours to charge a fully discharged mower).

FAST CHARGING RATE - NOTE: Fast Charge mode is only on if the fast charge button J-2is depressed. Use this mode only when neces- sary to improve task completion.

When in this mode, the red light J-1, will be flashing on and off indicating that the battery is being charged at a faster rate. After about 30 minutes the initial fast charge cycle is complete, and approximately 80% of full charge is available. The light will change to a flashing green light.

After approximately 3 hours of fast charging the battery will be fully charged, and the light will change to a continu- ous green light indicating a maintenance mode.

4. It is recommended to leave the battery on constant charge (between mowing uses) for optimum performance dur- ing the mowing season.

OPERATION

KNOW YOUR MOWER

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR MOWER. See “Functional Description” to

familiarize yourself with the location of various controls and adjustments. Save this manual for future reference.

SAFETY KEY

DANGER : SHARP MOVING BLADE.

In order to prevent accidental start-up or unauthorized use of your

Cordless Mower, a removable safety keyK-1has been incorporated into the design of your mower. The mower will be completely disabled when

the Safety Key has been removed from the mower.

NOTE: THE SAFETY KEY HAS A HOLE IN THE CENTER TO ALLOW FOR STORAGE ON A NAIL, OUT OF THE REACH OF CHILDREN. DO NOT TETHER SAFETY KEY TO MOWER.

DANGER: ROTATING BLADES CAN CAUSE SERIOUS INJURY. TO PREVENT SERIOUS INJURY,REMOVE SAFETY KEY WHEN UNATTENDED, OR WHEN CHARGING, CLEANING, SERVICING, TRANSPORTING, LIFTING, OR STORING MOWER.

TO TURN MOWER ON

Insert safety key L-1into the switch housing, until it is fully seated inside housing. The mower is now operational.

DANGER: SHARP MOVING BLADE. NEVER ATTEMPT TO

OVERRIDE THE OPERATION OF THIS SWITCH AND SAFETY KEY

SYSTEM AS SERIOUS INJURY COULD RESULT.

ON-OFF SWITCH (BAIL HANDLE) - FIGURE L

Your mower is equipped with a special on-off switch system. To operate the system, first push button L-1on side of switch housing, then pull the bail handle (switch lever) L-2to the handlebar L-3. To turn the mower off, just release the bail handle.

Once the bail handle has returned to the original position it will activate the “Automatic Braking Mechanism”. The motor is electrically braked and the mower blade will stop rotating in 3 seconds or less.

8

Image 8
Contents VEA EL Español EN LA Contraportada Please Read Before Returning this Product for ANY ReasonKEY Information YOU should Know Read ALL Instructions Before crossing walk, roads, patio and gravel drivesPersonal injury, including the following To Reduce Risk of InjuryWith no cracks or deterioration USE of Extension CordsNever wear radio or music headphones while operating mower Contain long hairUnclog the chute or remove anything from under the deck Keep Hands and feet away from cutting areaAssembly Handle Assemblyfigure CHandle Adjustment Figure D PreparationAssembling the Grass Catcher Figures E1, E2, E3, E4 Grassbag Frame ClipBattery Removing Battery from Mower Figure HCharger Safety Rules Important Safety InstructionsOperation Installing Grass Catcher Figure N, O Safety Shield and Rear Door Figure MMeets Cpsc Safety Requirements Mower OverloadDischarge Mode Your mower is now in Bagging mode Mulching ModeON-DEMAND Mowing TipsMaintenance Removing and Installing Blade Figure RMulching Mowing Tips Wrench R-2 as shown in figure RCleaning Blade SharpeningBlade Balancing LubricationBattery Service and Installation Rbrc Seal Battery RecyclingStorage Position OFF-SEASON StorageProblem Solution Battery and mower perform much better if charged fullyWarranties Bag full. Empty bag more oftenGuide DʼUTILISATION Lire Toutes CES Directives Conserver CES Mesures Bon calibre à utiliser, consulter le tableau suivant Pièce, est endommagé, il faut fairePréparation AssemblageDéballage Illustrations A, B AvertissementDans les plaques Ensemble DE Poignée Figure CRéglage DE LA Poignée Figure D Réglage DE LA Hauteur DES Roues 38 MM À PileRetrait DE LA Pile DE LA Tondeuse Illustration H Reporter À LA Section SUR LE Rangement Hors SaisonFonctionnement Procédure DE Charge ILLUSTRATIONSI, JConnaître SA Tondeuse CLÉ DE SûretéDémarrage DE LA Tondeuse Interrupteur DE MARCHE/ARRÊT Anse Illustration LSurcharge DE LA Tondeuse Écran Protecteur ET Panneau Arrière Illustration MInstallation DU Collecteur Dherbe « Sélection DE Mode »Conseils Pour LE Déchiquetage Mode de déchiquetageConseils Pour Tondre LA Pelouse Retrait ET Installation DE LA Lame Illustration R EntretienAffûtage DE LA Lame Lors DE Laffûtage DE LA LameÉquilibrage DE LA Lame NettoyagePrévention DE LA Corrosion Transport ET RangementEntretien ET Installation DE LA Pile Rangement Hors SaisonLE Sceau Srprc Recyclage DES Piles Rechargeables 800Problème Solution Problème RemarqueLa tondeuse ne ramasse pas lherbe coupée dans le sac Moins. Ne pas couper plus du tiers de la longueur totaleManual DE Instrucciones Pautas DE SEGURIDAD/DEFINICIONES Page Deben usarse piezas de repuesto idénticas DeterioroUSO DE Cables Prolongadores Preparación EnsamblajeDesembalaje Figuras A, A1, A2 Descripción DE LAS Funciones CM1936ZF2Ensamblaje DEL Mango Figura C Ajuste DEL Mango Figura DEnsamblado DEL Recolector DE Césped Figuras E1, E2, E3, E4 Ubique el mango de manera que los orificios de éste quedenBatería Retiro DE LA Batería DE LA PodadoraLa empuñadura F-2 y manténgala así Sección DE Almacenamiento Fuera DE TemporadaOperación Para Encender LA Podadora Sobrecarga DE LA PodadoraInstalación DEL Recolector DE Césped DE Seguridad Y Puerta TraseraLA Deje SIN Supervisión Aunque SEA Durante UN Período Breve Operación Según RequerimientoConsejos Para EL Corte DE Césped Mantenimiento Consejos Para EL Corte DE Césped Para Formar MantilloRetiro E Instalación DE LA Hoja Figura R InalámbricaAfilado DE LA Hoja Simetría DE LA HojaLubricación LimpiezaTransporte Y Almacenamiento Posición DE AlmacenamientoAlmacenamiento Fuera DE Temporada Mantenimiento E Instalación DE LA BateríaGarantías Problema Solución Esta Garantia no Aplica Cuando NotaAños DE Garantia Solamente Para Propositos DE Mexico