Black & Decker CM1936ZF2 instruction manual Mower Overload, Installing Grass Catcher Figure N, O

MOWER OVERLOAD

To prevent damage due to overload conditions, do not try to remove too much grass at one time. Slow down your cutting pace, or raise the cut height.

MEETS CPSC SAFETY REQUIREMENTS

Black and Decker Mowers conform to the safety standards of the American National Standards Institute, and the U.S. Consumer Product Safety Commission. The blade turns when the blade motor is running.

SAFETY SHIELD AND REAR DOOR - FIGURE M

The safety shield M-1is designed to minimize the throwing of stones or other objects by the mower blade backward from under the mower deck. The shield, along with the rear door M-2, minimizes the possibility of accidental foot contact with the blade. DO NOT operate mower without the safety shield and rear door in place.

Sharp moving blade. Do not operate the mower if the

rearDANGER:door is not closed under spring tension as serious injury could result.Take your mower to the nearest service center for repair.

INSTALLING GRASS CATCHER - FIGURE N, O

1.Release bail handle to turn mower off, wait until the blade stops and

remove safety key.rear

2.Reaching down between the mower handles, raise the discharge door N-1to a vertical position and hold the door up. Ensure that the mulch insert N-3has been removed.

3.Pick up the grass catcher N-2by the handle O-3and place the grass catcher between the mower handles as shown.

4.Position the grass catcher hanger hooks N-4on the mower as shown in figure O. Release the rear discharge door.

Sharp moving blade. Never operate the mower unless

theDANGER:hanger hooks on the grass catcher are seated properly on the mower and the rear discharge door rests firmly against the top of the grass catcher as serious injury could result.

M	2	I
		1
1	4
	2	3

9