Black & Decker CM1936ZF2 Storage Position, OFF-SEASON Storage, Battery Service and Installation

STORAGE POSITION		W
For more compact storing the mower can be stored in an upright position,
bewithchargedthe handleIn thisfoldeduprightoverposition.as shown in figure W. The mower can also
To place the mower in a convenient storage position:
1. Remove safety key.
2. Hold handle with one hand, pull and rotate one handle quick adjust
	knob on mower handle a quarter-turn to release the pin from the
	metal plate hole. Handle quick adjust knob will remain in this
	retracted position. Repeat for the opposite side handle quick adjust
	knob. Now the handle is free to move into another handle height
	position.
3. Swing the handle forward over the front of the mower.
4. Pull and rotate handle quick adjust knobs a quarter-turn to
	re-engage pins into metal plate holes. Shake handle slightly to ensure
	handle pins are fully engaged in the metal plates.
5. Now the mower can be rotated back onto its rear wheels as shown in
	figure W.
6. Be careful not to pinch power cord when folding and unfolding handle.
CAUTION: If handle is not in locked position in upright storage posi-
tion, the handle may fall back and cause injury or damage. Place blade
side against vertical wall.
	CAUTION: Pinch point. To avoid being pinched, keep fingers away
from area between handles when lowering.
OFF-SEASON STORAGE
1. In warmer climates to ensure optimal performance, it is recommended that the battery be maintained on constant charge.
2. The mower may be stored with the charger disconnected if all of the following conditions are met.
	- the battery is fully charged before storing. (Failure to store fully charged will shorten battery life).
	- the average temperature of the storage locationis below 50°F (10°C).
	- storage duration is less than 6 months.
BATTERY SERVICE AND INSTALLATION
When service or repair is required, it is recommended that you take your mower to an authorized Black & Decker Service Center.
When servicing or replacing batteries, please note:
•	Use only the same type and size of battery as originally supplied.
•	Do not dispose of the batteries in a fire. The cell may explode. See Battery Recycling information below.
•	Do not open or mutilate the batteries. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.
•	Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, bracelets, and keys. The battery or
	conductor may overheat and cause burns.
THE RBRC™ SEAL (BATTERY RECYCLING)
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the lead acid battery (or battery pack) indicates that the costs to
recycle the battery (or battery pack) at the end of its useful life have already been paid by Black & Decker. In some areas, it is illegal			Pb
to place spent lead acid batteries in the trash or municipal solid waste stream and the RBRC program provides an environmentally
conscious alternative.

RBRC in cooperation with Black & Decker and other battery users, has established programs in the United States and Canada to

facilitate the collection of spent lead acid batteries. Help protect our environment and conserve natural resources by returning the lead acid battery to an authorized Black & Decker service center or to your local retailer for recycling. You may also contact your local recycling center for information on where to drop off the spent battery, or call 1-800-544-6986.

Accessories

Recommended accessories for use with your mower are available from your local dealer or authorized service center. If you need assistance regardingWARNING:accessories, please call:

The use of any accessory1-800-544not-6986recommended for use with this lawn mower could be hazardous.

p/n 242501-05 REPLACEMENT GRASS BAG MB-1200 REPLACEMENT BLADE

RB-3610, RB-3612 or RB-3675 BATTERY PACK

FC3600 FAST CHARGER

HERE ARE SOME HELPFUL HINTS TO GET THE MOST FROM YOUR BLACK & DECKER CORDLESS MOWER...AND KEEP YOUR LAWN LOOKING BEAUTIFUL

1. Lawns should first be mowed in the spring when the grass is about 2-1/2 to 3 inches (63mm) to (76mm) high. Mowing too early restricts the grass root systems which renew themselves every spring. New grass should be mowed when it is about 2-1/2 inches (63mm) high.

2. Do not remove too much grass blade surface at one time...never more than 1/3 of the leaf height during each cutting. Cutting too close “shocks” sensitive grass blades, resulting in a shallow root system and thus making it more difficult for your lawn to reach water in the soil.

3. Lawn care experts say that excessively close cutting is responsible for much of the difficulty experienced on many lawns. The depth and strength of the roots of grass are almost exactly proportional to its growth. Grasses of mature lawns often are seriously injured when mowed shorter than 1-1/2 inches (38mm), and a height of 1-1/2 to 2 inches (38mm) to (51mm) is preferred on large lawns.

4. Mow your lawn when it is dry to avoid clumping of wet grass. If you have a choice, late afternoon is the ideal time for mowing, not only

13