40CHAPTER 4: NETWARE CLIENT AND SERVER DRIVER INSTALLATION
Intelligent Auto Install Requirements
To use the Intelligent Auto Install program:
■Make sure that your PC has only one 3C905C NIC installed.
■Make sure that you are using NetWare 3.x or 4.x as your network operating system.
■Make sure that your PC has at least 1 MB of available hard drive space.
If you have more than one 3C905C NIC installed, follow the NetWare installation instructions in the 3Com NIC Configuration and Diagnostic program for DOS. (See the DOSDIAG.TXT file located in the HELP directory on EtherDisk diskette 3 for instructions on using this program.)
Running the Intelligent Auto Install Program
To run the Intelligent Auto Install software to install the client software and drivers for a NetWare network:
1Install the NIC and connect it to the network, as described in Chapter 2.
2Reboot to DOS.
3Insert EtherDisk diskette 3 in drive A.
4At the DOS prompt, enter: a:install
The EtherDisk diskette main menu appears.
5Select Auto Install and Config for NetWare and press Enter.
6Select DOS, Windows 3.1x, or Windows for Workgroups 3.11, and follow the instructions.
7When the installation process is finished, remove EtherDisk diskette 3 and reboot the PC.
If you are running Windows 3.1x, after you connect to the NetWare server, run the WSINSTALL program for full Windows support. Contact your system administrator for the location of this NetWare utility.
