74APPENDIX B: DYNAMICAccess SOFTWARE INSTALLATION AND CONFIGURATION
Table 12 DynamicAccess Software Minimum Client Requirements
Operating | PC Requirements | Recommended |
System | Microsoft Service Pack | |
|
|
|
Windows 95 | 486/75 MHz CPU | Windows 95 OSR2 or |
| 16 MB RAM (32 MB recommended) | Service Pack 1 |
| 5 MB available hard drive space |
|
|
|
|
Windows 98 | 486/75 MHz CPU | None |
| 16 MB RAM (32 MB recommended) |
|
| 5 MB available hard drive space |
|
|
|
|
Windows NT 4.0 | Pentium/100 MHz CPU | Service Pack 3 |
| 32 MB RAM |
|
| 5 MB available hard drive space |
|
|
|
|
Windows NT 3.51 | Pentium/100 MHz CPU | Service Pack 5 |
| 32 MB RAM |
|
| 5 MB available hard drive space |
|
|
|
|
Installing DynamicAccess Software
To install DynamicAccess software:
1Make sure that the NIC and its software are installed on your PC.
See “Verifying Successful Installation” in Chapter 3 to confirm that the NIC is properly installed in the PC.
2Start Windows.
3
This file is automatically copied to your hard drive during the NIC driver installation into the following directory:
■Windows 95/98 — C:\WINDOWS\SYSTEM
■Windows NT 4.0 — C:\WINNT\SYSTEM32
■Windows NT 3.51 — C:\WINNT35\SYSTEM32
If you cannot locate the file on your hard drive, copy the file from EtherDisk diskette 2 to the appropriate directory.
The file is expanded and the DynamicAccess software is installed on your PC.
