Verifying Successful Installation

75

Verifying Successful Installation

After DynamicAccess software is installed, the following changes are visible in the Windows Network control panel:

For each physical NIC installed in the PC, a virtual NIC entry appears in the list of network adapters.

All protocols are re-bound to the virtual NIC. The bindings to the physical NIC are still intact.

A 3Com DynamicAccess software entry appears as a protocol.

A 3Com DynamicAccess software icon is installed in the Windows Control Panel.

Configuring DynamicAccess Software

Contact your system administrator about using

DynamicAccess software at your site.

DynamicAccess software configuration instructions are intended for network administrators who have experience installing software and using management tools for an Ethernet network.

The instructions in this section are for configuring DynamicAccess software on a local PC. You can obtain the complete configuration instructions by expanding the downloadable file that contains the DynamicAccess software from the 3Com World Wide Web site:

http://www.3com.com/dynamicaccess

To view the complete configuration instructions you need a Web browser. You do not need to reinstall the software.

To configure DynamicAccess software on a local PC:

1Double-click the 3Com DynamicAccess icon in the Windows Control Panel.

The Traffic Prioritization tab of the DynamicAccess Software Setup screen (Figure 15) appears.

Page 75
Image 75
3Com 3C905C-TX-M, 3C905C-TX manual Verifying Successful Installation, Configuring DynamicAccess Software