3Com 3CR990-TX-97, 3CR990-TX-95, 3CR990SVR97 manual Server Feature Commands, Group, Display status

108CHAPTER 5: INSTALLING NETWARE CLIENT AND SERVER DRIVERS

Server Feature Commands

DynamicAccess server feature commands for NetWare can be used to create sophisticated configurations of groups and for troubleshooting. You can enter them at the NetWare command line or add them to the appropriate NCF file. The commands are summarized below.

As shown in the examples, all commands are preceded by the keyword lbrsl.

group

This command creates groups from specified slot parameters for primary and secondary NICs.

Syntax

Example

lbrsl group lb addr RxIPAddr pri_slot sec_slot [sec_slot ...]

lbrsl group rsl pri_slot sec_slot [sec_slot...]

where:

lb specifies a load balancing group.

rsl specifies a resilient server link group.

RxIPAddr is a dedicated IP address for the load balancing group

pri_slot is the PCI slot number of the primary NIC. sec_slot is the PCI slot number of a secondary NIC.

lbrsl group lb addr 192.1.1.100 10001 10002

lbrsl group rsl 10001 10002

Default None

display status

This command displays information about all groups, or if a primary slot parameter is specified, only about the specified group. A separate message is displayed for each loaded frame type. Board numbers are also displayed. Information about the relationship between the board numbers and the frame types is shown in the NetWare 5 Console Monitor. On the Available Options screen, select LAN/WAN drivers for this information.