3Com 3CR990-TX-95 manual Verifying Successful Installation, Configuring the DynamicAccess LAN Agent

Installing the DynamicAccess LAN Agent for a Client NIC 57

8Do one of the following:

■If you selected Windows 95/98, click Install DynamicAccess Technology for Windows 95/98.

■If you selected Windows NT 4.0, click Install DynamicAccess Technology for Windows NT 4.0.

The DynamicAccess Software Installation program starts.

9When the DynamicAccess Technology installation is finished, exit the EtherCD, and then exit Windows.

10Restart the PC.

You must restart the PC to complete the installation.

Verifying Successful Installation

After the DynamicAccess LAN agent is installed on the client PC, the following changes are visible in the Windows Network control panel:

■For each physical NIC installed in the client PC, a virtual NIC entry appears in the list of network adapters.

All protocols are re-bound to the virtual NIC. The bindings to the physical NIC are still intact.

■A 3Com DynamicAccess LAN agent entry appears as a protocol.

■A 3Com DynamicAccess LAN agent icon is installed in the Windows Control Panel.

Configuring the DynamicAccess LAN Agent

Contact your system administrator about using

DynamicAccess technology at your site.

The DynamicAccess LAN agent configuration instructions are intended for network administrators who have experience installing software and using management tools for an Ethernet network.

The instructions in this section are for configuring the DynamicAccess LAN agent on a local client PC. You can obtain the complete configuration instructions by accessing the DynamicAccess Software User Guide on the EtherCD.